What are the effects of orientation and diameter on condensation?

More Erol Bicer's questions See All

How do you call a single nozzle bubble column reactor?

Hello, everyone! I am doing research on pool scrubbing and I am looking for experiments where a gas (preferably non-condensing) is injected into a pool by a single nozzle. I thought I could...

06 September 2020 7,230 3 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Is there any rich, publicly available English literary corpus?

Hi everyone. I am looking for a rich corpus in English literature, a one which includes literary prose ( e.g., novels or short stories) . can anyone propose a good one? Best regards Fatemeh

01 March 2021 1,970 2 View

Can we distinguish the type of free fluid inside the pelvic and abdominal cavities whether blood or serous fluid using the ultrasound?

during ultrasound examination of acute abdomen, sometimes we see free fluid , can we know the type of fluid ,whether blood or not , using ultrasound only? if yes , what are the sonographic...

01 March 2021 7,476 4 View

How much pressure we can reduce at the outlet to avoid Reverse Flow?

I am simulating Heat Exchanger. I have tried and tested all the methods to resolve this issue from the internet like refining mesh, improving skewness and orthogonal quality ,extending outlet to...

01 March 2021 6,985 3 View

How to show arrows over the streamlines in CFD-post?

I follow this to make streamlines like the photos attached below: (software- CFD post-processing) First I plot the 2D streamline over a surface "streamline 1". them I plot a vector by the...

01 March 2021 8,668 3 View

Could you please recommend some good journal that accept very long revie papers (approximately 6000+ words) in neurosurgery, cancer biology ?

01 March 2021 8,087 3 View

How to increase mesh quality of a cfd model in ansys fluent?

How can one improve mesh skewness, orthogonality, aspect ratio?

28 February 2021 7,730 3 View

What is the value of Conference Review Paper?

How much value does a review paper carry in a higher study aspirant student's profile which is presented in a Peer Reviewed Scopus Indexed conference?

27 February 2021 2,068 3 View

Centrality measures computation in Biblioshiny/ Vosviewer?

26 February 2021 7,279 2 View

Ali Benhmidene

Dear Erol,

Erol Bicer

Dear Dr. Benhmidene,

Thank you for sending the thesis. It sure is a good reference. However, what I am looking for is on-tube condensation rather than in-tube.

Thank you.

Best regards,

E.B.

Dear Mr. Pertsevyi,

Thank you for sending the article. It's such a good one to refer. However, my main focus is orientation and the diameter effect which is not included in this study.