12 Questions 12 Answers 0 Followers
Questions related from Damian Badora
Hello Dear Users. Does the default SWAT representation of orchards show their planting, growth and harvesting? Current Management Operations: Year OP_NUM Operation Crop Heat Units 1...
18 May 2022 5,687 2 View
Hello SWAT users, I would like to design ponds in the catchment area. I wonder if in this case it is enough to enter the parameters of the ponds in the .pnd files, or should they also be...
08 March 2022 7,805 1 View
Hello, honorable forum members. I have a question related to ponds, retention tanks, etc. in the SWAT model. What water balance parameters are affected by adding pond parameters in the .pnd...
05 March 2022 4,550 3 View
Hello dear Users. Is it possible to calculate the number of water stress days in a specific year? I know that the average number of days with water stress is given in the output.std file, while...
21 January 2022 7,317 4 View
Dear SWAT users, I have a big problem with two conservation practice in SWAT model: Grassed Waterway and Filter Strips. I wanted to use Grassed Waterway or Filter Strips in a SWAT model. I added...
04 January 2022 2,020 3 View
Hello Dear Users! I have a problem with low value of surface runoff. In my output.std is: PRECIP = 620.9 MM SNOW FALL = 52.53 MM SNOW MELT = 52.25 MM SUBLIMATION = 0.28 MM SURFACE...
14 October 2021 9,079 4 View
In Poland, we have wind speed data collected from 10 meters according to the WMO (The World Meteorological Organization) standards. In the SWAT manual, the data is accepted for the model from a...
11 August 2021 4,264 5 View
I have a problem with permanent wilting point WP. According to the formula WP = 0.40 * ((% CLAY * Bulk Density) / 100). My data shows that% CLAY = 5%, BulkDensity = 1.55. After converting, I have...
23 June 2021 2,134 2 View
Hello dear users. I wonder if I can calculate the Field Capacity with the data from the output.std file. There are SW and PERCOLATE values for each month. In SWAT Theoretical I found the pattern...
08 June 2021 6,932 0 View
I wonder how many HRU areas should I do in my catchment area. The catchment area of 30,000 ha is divided into 31 sub-basins. Upland area with a slight slope. 14 landuses. The 3 landuses are...
24 April 2021 3,066 4 View
Hello everyone, I have a calibration problem. After a few iterations of the model, I get a chart with high flows at the beginning and low flows at the end that do not match the measured flows. ...
02 January 2020 1,873 4 View
Hello Dear Users! Recently, I was able to calibrate and validate the SWAT model. But I started to wonder if all the parameters were correct. I was particularly worried about the CN2 parameter....
01 January 1970 653 2 View
