10 Questions 20 Answers 0 Followers
Questions related from Armin yousefi kanani
Hello Guys I know so many of you have the same question when you start using cohesive element in abaqus. This section is a bit confusing E/Enn does not mean dividing. It simply means Young modulus...
08 August 2019 7,767 4 View
Hello As it can be seen from below figure my simulation and experiments results are really close to each other. I just do not understand why load increases suddenly after 4 mm displacement in...
01 January 2019 4,196 0 View
I have flexible adhesive the Maximum stress is around 2.5 MPa and strain is around 150%. When we want to calculate Young modulus for normal material we normally take values from 0.05% to 0.25%...
01 January 2019 7,915 0 View
I want to plot load vs Displacement. For this I'm using the "sum" command in abaqus to add the magnitude of all the reaction forces on the fixed nodes but the load value is very low, i.e.,less...
08 August 2017 4,349 11 View
Hello I have problem with unit system in abaqus. I have already checked tables and discussions about this subject in internet and I am confused and looking for Numerical example. Could you please...
07 July 2017 9,421 5 View
I am currently working on adhesive joint. I want to do experimental test (DCB and ENF) to find cohesive zone information for my simulation. I am using Ansys software could anyone simply explain...
04 April 2017 788 0 View
For example in tensile test displacement rate is 0.76 mm/min. My question is that how can i give exactly the same rate in ANSYS. Regards Armin
03 March 2017 3,166 0 View
Please check my page for tutorials
01 January 2017 4,292 4 View
Please check my Youtube channel:
10 October 2016 2,533 1 View
Hello I want to analysis composite under in-plane loading. I have 2 problems 1- I could not choose proper boundary condition. When I applied boundary condition solved by R Jones my results is not...
03 March 2015 5,109 5 View
