Why the d.c. electrical conductivity of TiO2-reduced graphene oxide composite exhibits lower conductivity in higher graphene content? references?

04 April 2017 0 1K Report

in which way the surface recombination contributing in lower electrical conductivity??

Badges
Science topic

More Ramamoorthy Raja's questions See All

How can we relate the surface area of the powder samples with pore size and pore volume?? can some one suggest a good articles?

i have prepared tio2/reduced graphene oxide composite and i found that the surface area of samples are increasing with addition of rGO. pls someone explain this effect

02 March 2018 9,558 0 View

What is the difference between graphene and carbon quantum dots??

both quantum dots have the same graphite structure with lattice spacing around 0.34 nm. how can we differentiate?

09 October 2017 6,657 7 View

The D.C.Electrical conductivity of TiO2-graphene composite is decreased for higher graphene concentration. why?? any ref for this problem?

sol-gel routed TiO2-graphene composites show higher electrical conductivity but it is decreased for higher graphene concentration..why??

31 December 2016 4,266 4 View

Short Synthesis of Graphene Oxide from Natural Graphite Flakes?

I am in search of a modified Hummer's method, which can be used to synthesis graphene oxide within 6-8 hours. As I am a student it is not allowed for us to work after 5 in the laboratory. So I am...

01 August 2024 8,368 2 View

How can I separate graphene from amorphous carbon of similar particle sizes?

The starting material is a finely ground powder. Some particles contain more graphene than others.

30 July 2024 3,978 2 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

How to calculate conductivity using Electrochemical Impedance Spectroscopy's Nyquist plot?

Hello everyone, I am new to this characterization but watching videos on youtube I have already plotted a Nyquist plot (Z' and -Z'') and already fitted models on my material using Zsim. But now I...

29 July 2024 1,376 0 View

Provided that the shale conductivity termed here x increases with temperature, how could we compute it at reservoir temperature ?

one could use Waxman and Thomas (1974) work?

22 July 2024 6,637 0 View

How to convert magnetic conductivity from SI to lattice units?

I'm simulating a magnetohydrodynamic problem of blood flow using lattice Boltzmann method in lattice units and I need to convert the magnetic conductivity to lattice units. The physical value is...

07 July 2024 5,243 0 View

Graphene and graphene oxide as cancer factor?

Please, can any one inform us about risks of graphene and graphene oxide as a factor of cancer growth?

28 June 2024 6,815 4 View

How to eliminate imaginary phonon frequency in phonon dispersion of Coved Graphene Nanoribbons?

Dear all, I want to calculate the phonon dispersion of 4CNR-1-0 (structure is in Fig. 2 (b) in this article Designing coved graphene nanoribbons with charge carrier mob... ) and then calculate...

17 June 2024 6,911 2 View

How do we measure the electrical conductivity of this magnetic nanocomposite?

A magnetic nanocomposite has been synthesized and its electrical conductivity needs to be measured. What analysis and technique can be used to measure the electrical conductivity of this magnetic...

16 June 2024 7,488 3 View

Do we need a femto laser for good LIG?

Do we really need a femtosecond laser for Laser-induced graphene(LIG) production on polymers? Other than better resolution and lesser thermal damage is there any other advantages?

13 June 2024 5,294 0 View