Why the bending instability is high at high SOD in near field electrospinning?

Sudipta Bain @Sudipta-Bain

03 March 2017 0 6K Report

In near filed electrospinning I am experiencing high bending instability at high SOD? Why is it happening?

More Sudipta Bain's questions See All

Is Integer Optimization problem a Convex Optimization problem?

Please explain briefly.

04 July 2023 5,282 4 View

Adhesion Promoter for Ebeam Resist ZEP520A on Si wafer other than HMDS?

We don't have HMDS vapor priming, unfortunately. Is there any other Ebeam resist adhesion promoter that can be used by spin-coating onto the substrate?

12 April 2023 8,594 1 View

How to improve the solubility, dissolution rate and bioavailability of Glimepiride drug?

There are several drug modifications techniques like functional group modification, PEGylation, Amino acid substitutions, ligand conjugation, pH modification, dispersion enhancers etc. Can we use...

06 March 2023 8,036 1 View

ABAQUS Convergence issues-'Too many attempts made for this increment/ The plasticity/creep/connector friction algorithm did not converge at X points'?

I have been working on a pile-soil interaction model in ABAQUS where the soil is consisted of 6 layers (1 Clay + 5 Sand layers or 1 Sand+ 5 Clay layers). My problems are as follows: a. When I made...

10 February 2023 5,514 1 View

How do I mix two different resists PMMA and ZEP520A at a 2:1 ratio?

I am trying to achieve a tunable undercut profile by using bi-layer resist stack PMMA(Top)/PMMA-ZEP 2:1 Ratio(Bottom). I am pretty new to fabrication; hence, I am not sure how do I mix the PMMA...

11 January 2023 6,765 2 View

Can anyone share some recente results on Radon emissions during earthquakes?

I am looking for some recent works on radon emissions during earthquakes.

25 December 2021 5,329 0 View

How to make Cytochrome C standard curve ?

Can anyone send me the protocol for making the standard curve of Cytochrome C from horse heart? I have faced some problems in making the concentration of 0.0025nmol to 0.02nmol of Cytochrome C...

22 November 2021 7,834 0 View

How to run NACCESS in Biopython module to perform accessible surface area calculation?

I am using NACCESS available in Biopython for the first time. The document or manual says to use this: Bio.PDB.NACCESS.run_naccess(model, pdb_file, probe_size=None, z_slice=None,...

15 July 2021 7,944 3 View

How can I solve the error in Abaqus mentioned below?

I am using SANISAND to simulate a triaxial compression test under monotonic loading. But every time my simulations break and give the same message "Abaqus/Implicit Packager exited with an error -...

27 April 2021 2,445 7 View

Is there riverbank erosion a really problem in Europe? If then how it is being controlled?

Riverbank erosion is the major issues especially major rivers in the south-Asia. Different methods were taken to reduce the loss due to it. However, small rivers also causing problem which could...

13 April 2021 9,395 7 View

Using OBD technique i am trying to measure laser induced shockwaves velocity i found that at start velocity increases and then decay?

i am unable to interpret why its increases in start as shown in figure

11 August 2024 2,179 1 View

Hello researchers Is this a random laser or just fluorescence?

I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.

09 August 2024 9,894 2 View

Fabrication of narrow glass capillary (inner diameter 200~500 nm)?

I need a very narrow glass capillary for my research. How can I make a glass capillary with an inner diameter of around 200 to 500 nanometers?

08 August 2024 8,915 0 View

What procedure should I follow for current controlled PPy film electrochemical deposition on ITO?

For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...

06 August 2024 3,176 0 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

Best mask design for metal deposition aiming build a Perovskite solar cell device?

What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?

31 July 2024 4,835 3 View

What is the best method to detect the chemical composition of pollen ?

I have multiple small samples of grass pollen with anthers. I want to find a method to identify concentrations of proteins, lipids, and other various elements for these samples. any suggestions?

28 July 2024 5,331 1 View

How should operational parameters be selected when developing a pore-free laser welding technology?

There are three operating parameters - the laser power, the diameter of the focus spot and the scanning speed. It is necessary to obtain a seam of a given depth without pores. What parameter...

27 July 2024 7,168 2 View

Question about water vapor uptake of metal-organic frameworks?

I'm working on the atmospheric water harvesting, and i synthesized MOF by adding some materials into precursor and changing the conditions. (i followed Hydrothermal method) Actually, if MOF is...

24 July 2024 1,515 0 View

Can we fit a gaussian Fit on a LIBS Peak ?

Though much literature suggests fitting a Voigt profile on a LIBS peak, is it also possible to fit a Gaussian profile on the LIBS peak? I have 204 spectra files, and I am building a pipeline for...

23 July 2024 6,127 1 View