Why PEDOT:PSS can't form film?

Kaili Wang @Kaili-Wang-19

07 April 2022 1 1K Report

Hello,

I want to ask why my PEDOT:PSS can't form film, can I add something inside the PEDOT:PSS to help film formation?

Wabelha Mahde Mohmmed

موضوع مشوق جدا

Badges
Science topic

More Kaili Wang's questions See All

• What the possible Persistent Organic Pollutants and Heavy metals present in fluorspar, sediments, and water bodies around its mining area?

Approximate concentrations are require in compared with the WHO permissible limts

11 August 2024 2,723 1 View

Adhesion strength of coating?

How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...

10 August 2024 942 3 View

Why does the MFDFA algorithm need to calculate the profile of the time series?

As described in the Multifractal detrended fluctuation analysis (MFDFA) algorithm, it at first calculates the profile of the time series, and then other steps are operated on the profile....

05 August 2024 9,366 2 View

Polymer wear calculation?

What is the method for analytically calculating the wear and service life of polymer-polymer sliding pairs?

04 August 2024 1,078 1 View

Differences between deep seated landslides and slope destabilization?

Hi, Could someone explain the primary differences between deep-seated landslides and slope destabilization? In particular, definition and characteristics, mechanisms and triggering factors,...

02 August 2024 4,212 2 View

How to convert g/kg Humic acid dose to kg/ha?

I used humic acid at 0.044 g/kg soil in my pot experiment. But finally, I have to recommend kg/ha. Each pot's soil weight was 11 kg. What is the solution?

02 August 2024 7,186 6 View

Why Powder XRD is performed after cruhsing a crystal if Single Crystal XRD analysis of the same crystal has been performed already ?

What information we can get from PXRD analysis other than from SCXRD analysis of a crystal ?

30 July 2024 6,261 4 View

Why is it not common to see similar pairs in polymer sliding pairs?

If the pairs are similar, will it reduce the adhesion due to electric charges?

29 July 2024 3,185 2 View

A question about arbuscular mycorrhizal???

How long it takes for arbuscular mycorrhiza to establish and produce benefits under experimental conditions？

25 July 2024 5,208 2 View

Is it possible to run the AIMD within a system using virtual crystal approximation (VCA)?

I want to study the thermal properties of a mixed system which is constructed by virtual crystal approximation in VASP. When I try to run the ab initio Molecular Dynamics of this system in VASP, I...

19 July 2024 6,569 3 View

What procedure should I follow for current controlled PPy film electrochemical deposition on ITO?

For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...

06 August 2024 3,176 0 View

How can I better use imageJ to get good result on calculating surface area of a film accurately?

I have images of film formed on the bottom of a 50mL beaker, and I have been trying to figure out the surface area. I could easily use features on imageJ to do that, but I want to know which area...

23 July 2024 4,461 1 View

Why can't I detect the plasmon resonance angle with water?

I am trying to measure the plasmon resonance angle of gold film and pure water using the Kretschmann configuration and a 633nm laser. Without flowing water over the gold, I can detect a clear...

10 July 2024 4,719 3 View

I want to ask why the poly aniline film does not stick to the ITO type substrate knowing that I used the electrodeposition method?

In order to make a polyaniline film, I used the electrodeposition method and set all the conditions, but I noticed that the polymerization process is happening, but it doesn't stick to the...

09 July 2024 2,708 2 View

What is polymer/chemicals can increase the swelling index of a polymeric film?

Polymeric film such as latex rubber substrate or polymer

01 July 2024 8,343 4 View

How can we reduce the porosity of tungsten oxide (WO3) thin films during DC sputtering deposition (target: W, power: 100 W, 75 W, and 50 W)?

We are fabricating a tandem structure where a ~50 nm thick WO3 film is deposited between two metal films using DC sputtering. We use a mixture of Ar and O2 gases at different flow rates while...

01 July 2024 2,686 2 View

What are the potential effects of atomic-scale defects on the electronic and optical properties of thin films in emerging semiconductor materials?

Despite significant advancements in thin film deposition techniques, the precise role and control of atomic-scale defects in determining the properties of emerging semiconductor materials remain...

01 July 2024 5,745 1 View

How to solve the problem that the film obtained by magnetron sputtering on the ternary alloy target A2BC is ABC (not A2BC)?

Using magnetron sputtering with an alloy target composed of A:B:C in a 2:1:1 ratio, the resulting thin film composition is A:B:C=1:1:1. How can you achieve a A:B:C=2:1:1 composition? What are some...

24 June 2024 1,605 0 View

What is it that can affect the energy harvesting performance of a PVDF nanogenerator ?

I have made a PVDF film and now I am trying to see the film's performance. I have made contacts on the film with the help of silver paste and attached copper strips as electrodes. But, I am not...

24 June 2024 8,671 0 View

Is there any nformation about Cork Intrnational Film Festival?

i try to find the history of Cork Film Festival

22 June 2024 1,105 0 View