Why not getting peak valure in ferro/ferri redox couple for the electrochemical study of PCB gold electrode.?

Syama Sajikumar @Syama-Sajikumar

06 November 2023 0 108 Report

I am using Ruthenium redox couple. Here it working properly. but ferro/ ferri not getting

Badges
Science topic

Similar topics
Computer Science
Program

More Syama Sajikumar's questions See All

What are the various packages required in a freshly installed R program to conduct bibliometric analysis using bibiliometrix package?

04 January 2022 4,656 6 View

How can I individually separate phycocyanin and phycoerythrin from crude phycobiliprotein?

UV-Visible Spectrophotometric evaluation of crude phycobiliproteins shows absorption peaks corresponding to both phycocyanin and phycoerythrin. so, how can I separate both phycocyanin and...

04 February 2021 8,260 2 View

How to experimentally calculate the Poisson´s ratio of a Silicone hose?

I am investigating the the Youngs modulus and Poissons ratio of a CAC silicone hose (Armid fabric embedded). Is there any test to determine the Poissons ratio experimentally, I am conducting a...

27 August 2020 3,880 4 View

Can anyone help to identify the attached otolith, fish scale ( may same species) sorted from oceanic squid stomach ?

22 September 2016 5,227 3 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

How gold procurement?

Please note it

29 July 2024 4,920 3 View

How gold procurement?

https://www.cleanteqwater.com/resources/case-studies/gold-mine-australia/

29 July 2024 5,161 1 View

In passive sampling, can polymer-lipid partition coefficients be applied independent of environmental salinity?

For example, if low-density polyethylene (LDPE) is equilibrated with PCB contaminated marine and freshwater sediments, can LDPE-lipid partition coefficients be used to obtain equilibrium...

28 July 2024 263 1 View

How to draw photon-magnon coupling color plot in origin?

Please help me in plotting the photon-magnon coupling plot as shown below

14 July 2024 1,632 1 View

What is a diamond open access journal and difference between green and gold access?

12 July 2024 9,717 3 View

Why can't I detect the plasmon resonance angle with water?

I am trying to measure the plasmon resonance angle of gold film and pure water using the Kretschmann configuration and a 633nm laser. Without flowing water over the gold, I can detect a clear...

10 July 2024 4,719 3 View

I'm looking for a tool to evaluate the risk of bias in... Are there any recommended applications or platforms?

Dear researchers, In a systematic review (not a meta-analysis) compiling studies on various diagnostic systems against a specific pathogen. The most relevant parameters evaluated are the type of...

03 July 2024 9,069 3 View

Airborne Geophysics in Mineral Exploration ?

Appreciate your advice as I am asking about Airborne Magnetic Survey for mineral exploration (Gold and Associated Elements). What's the maximum depth for detecting subsurface extension and what...

02 July 2024 6,179 5 View

How to solve the question of ansys fluent?

Regarding the system coupling issue where the update of the solution component fails, the system coupling update for fluid flow (Fluent) triggered an exception: "Update Solution Failed."

30 June 2024 7,894 1 View