I am using 1/10 volume of 3M sodium acetate, pH 5.2, for DNA precipitation.
However, this salt is so high that it's making problems in electroporation (input = 1500V and 5ms; output = 680V and 0.8 ms) which is a much lower value and is the reason my transformation isn't working.
Can anyone please suggest how to precipitate DNA with lower salt?
What kind DNA you tried to precipitate? You can use 2/3 volume of Isopropanol for precipitation of DNA. I'm using this approach for Mycobacterium DNA precipitation
I can recommend the following method for drop dialysis to lower the salt, having used it many times to avoid arcing in electroporation.
Protocol
1. Pour 30–100 ml of dialysis buffer, usually double-distilled water or 1X TE (10 mM Tris-HCl, 1 mM EDTA, pH 8.0), into a petri plate or beaker.
2. Float a 25 mm diameter, Type-VS Millipore membrane (MF type, VS filter, mean pore size = 0.025 μm, Millipore, Inc. #VSWP 02500) shiny side up on the dialysis buffer. Allow the floating filter to wet completely (~5 minutes) before proceeding. Make sure there are no air bubbles trapped under the filter.
3. Pipette a few μl of the DNA droplet carefully onto the center of the filter. If the sample has too much phenol or chloroform, the drop will not remain in the center of the membrane and the dialysis should be discontinued until the organics are further removed. In most cases, this is performed by alcohol precipitation of the sample. If the test sample remains in the center of the membrane, pipette the remainder on to the membrane.
4. Cover the petri plate or beaker and dialyze for 1 to 4 hours. Do not allow the sample to flip or become covered with dialysis buffer.
5. Carefully retrieve the DNA droplet with a micro-pipette and place in a microcentrifuge tube. Rinse the spot on the membrane with 50 μl of 1X TE (10 mM Tris-HCl, 1 mM EDTA, pH 8.0) and add to the microcentrifuge tube.
6. Estimate the concentration of the DNA product using agarose gel electrophoresis or a spectrophotometer.
Notes
Step 4 may be tricky for those with shaky hands or poor handeye coordination. The filter has a tendency to move briskly around the surface as you touch it with the pipette tip. Practice with buffer droplets to master the technique before using a valuable sample.
Dialysis against double-distilled water is also recommended, especially if proceeding to another manipulation where EDTA might be a problem.
Steps 2 to 4 can be repeated with fresh buffer or for longer times if additional dialysis is required.
Reference
1. Silhavy, T., Berman, M. and Enquist, L. Experiments with Gene Fusions, Cold Spring Harbor, N.Y. Press (1984).
- Badges
- Science method