hello everyone,
I designed two-port antenna by CST 2018.
and it was simulated correctly.
but when evaluating envelope correlation coefficient I receive error like below:
Template based post-processing result "Env_Corr_Coeff from S":
Error in calling "Evaluate1D" function (Invalid y value, please check.)
what should I do for solving this problem?? :-((
Please check the formula and its variables used.
Once attach the image of the formula used.
I used template result from post-processing in CST.
I didn't write new formula.
I have been used this template before for different designs and it worked correctly!!
but recently it shows error after evaluate even for those designs. :-((
I attached this error bellow.
Hi Azadeh,
I think you did not set your frequency range correctly and they may not be on the same range ( Simulated and monitoring Frequency should be in the same range).
hope this works
- Badges
- Science topic