Why does the GCD curve rise above the voltage range?

19 April 2024 0 8K Report

Hello.

GCD analysis was performed in the 0-0.4 V range. At 1 A/g, the discharge time is about 3 seconds, and at other current densities, the graph jumps outside the specified voltage range (0-0.4). How can I get a proper GCD curve? Hg/HgO and Pt wire were used in 2M KOH.

I would appreciate it if you could let me know.

Badges
Science topic

More Eunseon Chae's questions See All

What is the problem with my siRNA transfection?

I tried a pool of 3 siRNA transfection in Hela cells using RNAiMAX but all of of them failed. 100nM conc siRNA and opti-mem were used at 40~50% cell confluency and then 6 hour later, added DMEM...

02 September 2020 9,096 4 View

Why is methylene blue commonly used to measure an active surface area of nanoparticles?

Among the dyes, why is methylene blue commonly used to measure an active surface area of nanoparticles(especially graphene derivatives)? I try to find the reason, but I cannot find it. Could you...

11 March 2020 2,963 4 View

What is the meaning of this peak in small angle scattering 1D pattern?

In small angle neutron scattering SAS (actually small angle neutron scattering, SANS), I obtained a 1D pattern showing a peak which is located over 1 inverse angstrom. The actual peak position is...

23 December 2019 2,523 2 View

How can I increase the yield of this compound?

Hi guys, I want to synthesize the compound in the below picture. (Ref from Chem. Commun., 2017,53, 3189-3192 ) Its synthetic procedure seems gabriel synthesis using...

06 March 2018 6,385 3 View

Why does DMSO show quintet in 1H NMR?

Hi guys, I learned that dmso peak in 1H NMR caused by proton exchange. So the peak at 2.5 ppm indicates dmso-d5 not d6 Also the dmso which have more exchanged proton like d4 or others can be shown...

04 March 2018 8,655 3 View

Why brine(saturated NaCl solution) is better than water in extratction?

Hi, I've learned extraction using brine. The reason that I learned was increasing polarity and removing water in organic phase. Then, how this can happen and why brine is better than pure...

10 February 2018 5,516 3 View

Sutter electrode holder leaking after applying positive pressure. How to fix?

I am using a Sutter electrode holder for my patch clamp experiments, but I'm having trouble keeping positive pressure inside my electrode due to a leak out of the back of the holder. I have added...

02 March 2021 5,829 1 View

Is there a deep reason for using the squared modulus of the wave function as the probability density of the existence of the particle?

I think we were all surprised at the first time we got to know quantum mechanics that the squared modulus of the wave function is the probability density of the existence of the particle? The role...

28 February 2021 6,282 9 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

Is there a suitable way to confine cell attachment area inside a multi-well plate?

Are there any types of cylindrical cell culture inserts that are designed to confine cell seeding area? Say, if I'm using a 12 well plate (3.5 cm^2/well), but only want to seed cells in the middle...

22 February 2021 7,127 4 View

Helix antenna coupling problem?

Dealing with a helix antenna, made with flexible material and not rigid like using a PCB board or wire. At the beginning of the helix is too close to the ground plane, causing coupling. How can I...

21 February 2021 4,453 3 View

Hi..how to isolate crude HDL (all subfractions) from human serum by size exclusion chromatography?

I would like to know about isolation of crude HDL from serum by SEC. Is it possible to perform with a serum sample volume of

19 February 2021 5,576 2 View

How to calculate the Atomic Polar Tensor using DFT ?

Dear friends, I am a beginner at DFT calculation. I have done a structure optimization using DFT- B3LYP/6-31G*, Nevertheless, I don't know How to calculate the Atomic Polar Tensor (APT) in...

17 February 2021 9,082 3 View

Measurement of water retention in organic substrates without a pressure plate?

Hello, I'm trying to measure the physical and hydrological properties of organic substrate media. Currently, I'm referring The book Soil sampling and Methods of Analysis by Carter and Gregorich....

09 February 2021 3,233 8 View

Does anybody know a public dataset of drop landing or jump landing maneuvers?

Dear all, In our project we would like to test different control strategies during drop landing compared to jump landing. After an intensive search I could not find a public dataset of drop...

09 February 2021 7,093 4 View

Any model suggestion for the Electronic Health Records dataset ?

I have sequentially measured the time-series Electronic Health Record patient dataset. This is 7 years of research and each patient's blood pressure, Hba1c, LDL, Hb, Baseline Age,...were measured...

09 February 2021 4,933 8 View