Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

How can we raise the figure when we writing a paper with Latex ?

Hi, everyone. I'm a starter to write a paper by Latex. But I have some difficulty using it. I'm writing the paper with 2 columns. And, there is one figure that occupies the 2 both-sides. I want to...

26 February 2021 3,738 3 View

Satellite orbit estimation using Recurrent Neural Network - what should I use?

Hello, I am a master's student studying in Yonsei Univeristy, Korea. I am trying to estimate the state of satellite, using Neural Network. Below is a simple flow of my study. 1. Train (t0 ~ t1)...

23 February 2021 6,383 3 View

What is the system of units used in the thermal conductivity by Spitzer and Harm?

23 February 2021 9,253 1 View

Can ethanol be used as an analgesic?

If ethanol has analgesic properties, why isn't it used for clinical purposes?

18 February 2021 8,227 4 View

How to decrease the time for publication of paper in a journal ?

It takes a lot of time in publishing the paper in the journal, from few months to a year so how one can able to decrease the time for publication.

17 February 2021 2,997 14 View

How many days do we need to detect adoptively transferred Treg in the tumor site in tumor-bearing recipient mice?

Hello, I've got a plan to isolate mouse splenic Treg (WT and KO of target gene) and inject these CD45.2 Treg into tumor-bearing CD45.1 mice. My question is how many days do I need to wait to see...

11 February 2021 8,238 1 View

Is it possible to antibody labeling with FITC cause antibody disfuction?

Hello, I studied how much bound my test antibodies to the target antigen using FITC labeling to test antibodies. I tested 3 types of antibodies, the elisa binding affinity and cytotoxicity...

07 February 2021 8,335 2 View

Can you use MTS assay with cells cultured in media containing phenol red?

I am trying to run a cell viability assay with LN229, but these cells are cultured in DMEM which contain phenol red. Is the MTS assay sensitive to the additional of phenol red in the media? If so,...

03 February 2021 9,478 2 View

Lighting for open field test behavior assay?

I am currently setting up our lab's behavioral space to run the open field test in rats, and I am trying to figure out how to set up lighting to evenly illuminate the open field chamber (a 90 cm x...

26 January 2021 1,399 3 View

How to delaminate copper in water-based anodes?

Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...

24 February 2021 3,785 3 View

Where can the fault diagnosis data set of lithium battery be found?

Most of the data sets on the network only contain good information about the voltage and internal resistance of lithium batteries. The data of faulty battery is missing. Who can help me, I will be...

21 February 2021 8,659 1 View

Not able to charge-discharge Li-ion coin cell at higher C rate ?

I am working on cathode material. I have made different Li-ion coin cell against Li metal using commercial available cathode materials such as LCO,LMO, LFP and NMC and also with the lab...

18 February 2021 1,450 3 View

No title

Hello. I ask for help - I need to get lithium tetraborate (soluble salt) from lithium carbonate and boric acid. In literature, everything seems to be simple - mix, ignite and - it's done. But it...

16 February 2021 9,523 2 View

What is the best supplyer for high quality lithium niobate?

Hi, I want the use lithium niobate for the frequency conversion from 1030nm to 515nm. We want to order bulk material and machine it to the required dimensions. There are numerous suppliers of...

07 February 2021 6,786 2 View

High Power control for 48V battery pack - High current control?

Hi, I am working on 48V Lithium-Ion battery pack. I am wondering if there is fast MOSFET (or any other technology), to control the current of charging and discharging the battery with high...

20 January 2021 1,717 4 View

Is it possible to calculate the energy stored (kWh) in a EV battery by knowing the cathode discharge potential and specific capacity properties?

For example, if I have the following data for a LiNi0,8Co0,15Al0,05O2 compound used in the cathode: - Specific capacity = 200 mAh/g - Average voltage = 3,7 V I have no information about the...

16 January 2021 3,038 2 View

How can i calculate diffusion barrier of Li ion on graphene nanoribon using SIESTA?

I'm a new siesta learner, I'm working on lithium-ion batteries, I have calculated adsorption energy but i am not able to calculate diffusion barrier of Li ion. kindly help me how to calculate...

14 January 2021 2,688 1 View

I have started to design a Lithium ion battery in Comsol. I need to merge the LIB model with PDEs. any idea how to do that ?

the electrode structure has secondary pore networks , so I need to use different governing equations for the electrodes. I tried to use PDEs , but I have not get any results. Does anybody have any...

02 January 2021 3,225 1 View

How to find x in LiFePO4 or LCO?

Dear Everyone, I am new to this battery field and want to know how to get x (amount of lithium (de)inserted) from the galvanostatic charge/discharge profile for any materials. I have attached...

26 December 2020 632 2 View