Nice Greeting,
I try to simulate a clay soil layer for geotechnical problem by using ABAQUS. I select Mohr-Columb plasticity for (material __mechanical), when I submit the job, I got an error "the consolidation analysis is not meaningful because no consolidation data have been given" could you please assist me to figure out this error and from where I have to input the enitial void ratio? Thanks in advance
Ali Tasalloti
As far as I know, for consolidation analysis you need to define void ratio, permeability, unit weight of water, and etc. Please refer to section 10.1.1 in "Abaqus Example Problems Manual" where a plain strain consolidation is shown as an example.
1 votes
0 thanks
- Badges
- Science topic
More Hiba al-adhami's questions See All
Similar questions and discussions