Salam,

send me your data I'll try to applied it; despite the tutorial I send you last time - I think- is well clear for reapplying your own data.

C Fatih

Chellai Fatih Salam professor, thanks for the reply. In reality i read what did you postulate the last time and i have gone to the link of package in the document that you indicated

i run cointARDL command in Gretl and is installed. The same for ADMBP it was succesfully installed.

Through the f x (paquatage de functions) i click on installed ADMBP and a case appears including many options as lagslest, setARDL....but they do not give me any results i dont know the procedures....Please can you kindly provide me the procedures because the documents that you send does not give the exact steps and i can not find any tutorials on ADMBP in youtube.

you have at first, uploid your data (as indicated in the example atteched in tutorial of this package) then you just to replace them by your own varibales; and run your functions .

Chellai Fatih yes i did professor, but i have a problem with lagselect command, i follow what they explain in the doc and i apply for lagselect (&b) (as showed in the image 01 with red) but it does not work for me (as shown in image 02 with red pen). Also i do not know from which criteria they choosed the highlighted figures with yellow colour..., please kindly check the two photos.

There is an error when you define ARDL parameters, you simply follow the tutorial, as indicated in this command:

# Set ARDL parameters scalar pqmax = 4 # max. lag length scalar condARDL = 1 # 1= conditional ARDL , 0= unconditional scalar infocrit = 1 #

Chellai Fatih I thought that I shouldn't put the sentences after the hashtag. Now by including them it works, thank you very mutch dear professor! i have only one and last question for long run , LRbeta() function does not work as you can see from the picture (i am sorry for all those questions)