Hi..how to isolate crude HDL (all subfractions) from human serum by size exclusion chromatography?

I would like to know about isolation of crude HDL from serum by SEC. Is it possible to perform with a serum sample volume of

19 February 2021 5,576 2 View

Why do we need to neutralize the charge of the system by adding ions before we proceed to energy minimization step in GROMACS ?

I am learning MD simulations using GROMACS and while I was doing a protein in water MD simulation a doubt raised. I was following the steps mentioned on the tutorials page and it said The system...

15 February 2021 5,514 4 View

Which is the best wavelength to study aerosol optical depth(AOD) related to climate reseach,which criteria must be adopted in choosing the wavelengh?

We are doing a study on impact of aerosol on precipitation. Which satellite data and which wavelength will be the best. or can some one suggest a criteria to be adopted to choose an instrument...

12 February 2021 6,324 3 View

How do we calculate 95% confidence intervals for RMSE?

I have two datasets (measured and modelled). I want to calculate 95% confidence intervals for RMSE. Cany anyone please help me with this? Thank you in advance

04 February 2021 5,439 6 View

Queries regarding the rain flow counting algorithm?

02 February 2021 9,790 2 View

How do Research Gate proceed to integrate in the reference data publications and citations the recently published journals ?

How do Research Gate proceed to integrate in the reference data for publications and citations the recently published journals - for instance for the last months of 2020 and for instance Intl J...

02 February 2021 9,336 7 View

How to take XRD of colloidal Ag NPs?

I have synthesized silver nanoparticles using sodium citrate as reducing agent. I have carried out XRD characterization by drop coating colloidal solution on the glass substrate ( since yield in...

27 January 2021 1,416 3 View

Doubt in DFT geometry preparation?

Hi all, I am trying to perform some ab inito DFT calculations using cp2k code. I have a unit cell of 120 atoms and would like to know how to refine or reduce the number of atoms in the unit cell...

20 January 2021 6,024 3 View

How to revive bacteria from glycerol stock?

19 January 2021 7,025 4 View

Is there a way to identify the clay mineral based on the Si:Al ratio that has been obtained through EDAX analysis?

I have come through a few literature,were the presence of particular clay mineral has been validated through the Si:Al ratio obtained from EDAX analysis. But, I would like to understand the basic...

08 January 2021 5,982 6 View

Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

Which database would give me this list of chemical components?

Dear colleagues: I would like to know if anyone knows of a database that gives me the parameters pH, K, K, Mg, P, C, N, Zn, Cu, Ni and Cd of common foods. I find a lot of information of proteins,...

26 February 2021 5,525 3 View

How does charge on working electrode changes with rising potential?

During performing CV of a GCE or modified GCE, we rise the potential in the first half of the cycle and reduce it in reverse half. During the first half, what is the nature of charge on GCE or...

25 February 2021 7,994 3 View

How to delaminate copper in water-based anodes?

Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...

24 February 2021 3,785 3 View

Why is NH4OH added in heavy metals limit test?

The limit test I'm referring to is USP method II. In this procedure you need to dropwise add 6N of NH4OH to the sample until it the pH is alkali. After that you need to dilute and add HOAc until...

23 February 2021 2,049 3 View

Thermal reduction of graphene oxide.?

I am trying to reduce graphene oxide by thermally but I have no proper information regarding this. Can any one help me regarding the details about temperature and time for the reduction of...

23 February 2021 4,155 4 View

What kind of steel moulds are used for hot pressing metal powders?

My main concern is that the metal powders should not weld to the mold surface and I should easily be able to eject out the pressed samples. I am looking for alternative for graphite moulds. The...

22 February 2021 2,965 4 View

Is there an ideal incubation time of RGO-modified SPCE before subsequent use, i.e., electrochemical characterization or further modification?

I notice that upon washing and air-drying of my RGO/SPCE surface and characterizing again via DPV, the current response towards ferricyanide probe significantly decreases. My worry is that the...

22 February 2021 5,324 3 View

No title

22 February 2021 9,932 11 View