Is there a way to relate spectral absorption coefficient and emissivity of an individual soot particle?
I am not sure but It is possible that there may be something in a seminal publication by Toloukian et al.
'Thermophysical properties of matter' edited by Y. S. Touloukian
IFI/ PLENUM publishers
I would start there!
Thanks for the suggestion. I am not able to access that publication online. Do you know where I can get it ?
Thanks.
31 December 2014 7,770 0 View
I am modelling porous medium combustion in FLUENT with a separate energy equation for the fluid and the solid zone. Since the temperature of the solid region is quite high (around 1200 K),...
01 February 2014 2,858 4 View
I wish to represent physical phase boundaries in a porous structure on a mesh. It seems to be quite simple to get a porous structure with the desired porosity by mere random allocation of solid...
31 December 2013 4,718 1 View
I'm trying to simulate combustion through an inert porous block. I was able to complete the simulation assuming local thermodynamic equilibrium between the solid and the fluid but since this would...
09 October 2013 1,487 3 View
Should I use th = acos(r) or th = acos(sqrt(r)) where r is a random number between 0 and 1. 'th' is the angle of the ray from the normal to the surface.
08 September 2013 4,975 5 View
I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?
11 August 2024 3,115 1 View
I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...
10 August 2024 4,005 2 View
"PUBLISHING IN A SCOPUS JOURNAL" Researchers are now at a cross road. The critical need to publish in a Scopus or ISI, etc journal is ever vital. Journal Publication fees must be submitted....
10 August 2024 8,621 1 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
Hello everyone, I am currently developing a thesis proposal and would appreciate your input on its viability and how to effectively carry it out. My proposed topic is: "Does the perceived threat...
10 August 2024 8,992 0 View
Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...
09 August 2024 7,892 0 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,048 2 View
Who will bear moral responsibility for the deaths of thousands of people in the event of an earthquake? Weeks and months remain before the onset of strong earthquakes that bring death to...
08 August 2024 6,134 12 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
The stability of the Solar System is a complex subject that blends the classical framework of Newtonian mechanics with the modern insights provided by General Relativity (GR). Understanding this...
07 August 2024 2,569 1 View