Resistivity of PVD TiNx thin films vs. N2 flow?

In the PVD of TiN thin films (~100A), I've found the resistivity of the TiN films dropped from ~100 to 60um*cm with N2 flow increasing up to the metallic mode ending point; then the resistivity...

21 February 2021 1,864 2 View

Do you have some articles to recommend about comparative experimental study about gas and water flooding with oil reservoirs?

I would like to know in the oil extraction, which is more efficient: gas flooding or water flooding? Will water flooding be more efficient in hydrophilic reservoirs with capillary...

29 December 2020 3,471 3 View

What does this PZC data mean?

I measured different kinds of catalysts which were dispersed in DI water.I firstly added certain amount of HCl and then used NaOH to titrate and measure the pH value. What does this result mean?

27 December 2020 5,728 4 View

How to inhibit the ion conversion between Mn4 + and MN2 +?

Dear scientists, I have a question to ask you, it is known that Mn4+ is beneficial to the soil, but part of Mn4+ in the soil is easy to be converted to MN2 +, is there any way to inhibit its ion...

21 November 2020 1,200 5 View

Failure in using Gene Pulser Xcell (Biorad) ?

02 October 2020 8,642 1 View

Hi everyone, how can we remove the snow-covered areas in global scale?

We obtained the global results using remote sensing reanalysis dataset. But the snow-coverd areas should be removed (like the blank area in the picture below, sources: Purdy et al., 2016). Does...

20 September 2020 3,463 5 View

How to set the fluent simulation species transport density item?

I use fluent to simulate species transport. The medium is sulfur hexafluoride and air. There is a density item under the mixture, and there is also under the fluid. Is there any difference between...

29 July 2020 7,414 4 View

How to detect brown pigments generated in red wine aging process ?

During aging or storage, the concentration of monomeric anthocyanins decreases rapidly, while low level of polymeric anthocyanins generates, and the color of wine turns brick-red gradually. In...

17 July 2020 6,032 4 View

How to calculate mode overlap ratio in Comsol ?

As is shown in attachment, there is hybrid plasmonic waveguide (HPW) and dielectric waveguide (DW), I want know how to calculate mode overlap ratio to evaluated the mode distribution similarity...

14 July 2020 2,275 3 View

Is there any organic solvent for MnCO3?

Since that my experiment could not be proceeded in aqueous. Anyone who know is there any organic solvent for MnCO3, the concentration could be as low as several mg/mL. Thanks

02 July 2020 9,654 19 View

Looking for Materials with high thermal expansion coefficient and high temperature resistance?

03 March 2021 8,272 1 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What are anisotropic electrical and optical properties of a semiconductor due to?

In some materials, properties such as band gap, thermal conductivity differ along different crystallographic axes. What are the basics?

01 March 2021 1,923 3 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

How can I assign a velocity along one direction to CO2 molecules in a molecular dynamics simulation using GROMACS?

Dear all, I am trying to perform a MD simulation about the interaction between CO2 and a polymer. I create my model, solvate it and perform the NVT and NPT equilibration. Now I am not able to...

26 February 2021 10,014 3 View

Why do a weight decrease for thermal degradation in nitrogen gas condition?

Hi all The question is related to TGA(Thermogravimetric analysis). Thermal degradation easily understood but why do samples weight decrease? altough just binding is broked, the weight of...

26 February 2021 1,100 5 View

Can thermal cycler machines be problematic during PCR?

Hi, my question is about the heating of thermal cycler machines and I hope some of you had experienced a similar thing previously. There are two thermal cycler machines in the lab(BioRad) and for...

26 February 2021 4,777 4 View

What could be reason for getting such type of graph for complex impedance in case of polymer blend films?

Its effect appears in real part of ac conductivity also. Can anyone suggest any reason behind it?

26 February 2021 3,487 3 View

CGA 300 Regulator for CO2 cylinder?

Has anyone ever tried to deliver CO2 with a CGA 300 regulator? I know that a CGA 320 regulator is standard for CO2. The issue is that I currently do not have any free CGA 320 regulators. I also...

25 February 2021 3,292 3 View

Modeling viscosity using model of Chung?

Hello, As part of simulation of gases mixture and water, I need to calculate viscosity of the fluid components and I am using relationships proposed by Chung et al. (1988). The irony is while I...

25 February 2021 8,053 5 View