Looking for Post-Doc position?

Hi everyone, I'm looking for Post-Doc position in : -Metal nano-oxide synthesis ( eco-design and application in environment): examples: ZnO, TiO2..... and/or - Nano-composites ( noble metal/ metal...

06 July 2018 3,474 2 View

How can we analyze defect structures of TiO2 using XRD and EDAX analysis?

How can we analyze defect structures of TiO2 using XRD and EDAX analysis?

04 May 2018 2,819 5 View

How to calculate the anatase / rutile molar ratio using XRD analysis??

How to calculate the anatase / rutile molar ratio using XRD analysis??

04 May 2018 659 5 View

How to prepare anatase-rutile TiO2 composite using TiO2 bulk?

Dear all, How to prepare anatase-rutile TiO2 composite using TiO2 bulk?

04 May 2018 1,713 2 View

How can we calculate dhkl using Electronic diffraction in this case?

How can we calculate dhkl using Electronic diffraction in this case? Thank you all.

02 March 2018 8,452 3 View

How to prepare soluble TiO2 using insoluble Ti2O3 as precursor in water?

How to prepare soluble nano-TiO2 (anatase) using insoluble bulky-Ti2O3 as precursor in water?

02 March 2018 3,261 0 View

How can we detect metallic silver / Silver oxide using SEM Observation?

How can we detect metallic silver / Silver oxide using SEM Observation?

01 February 2018 4,329 4 View

PostDoc request in bio-resourced nanomaterials for Environment?

01 January 1970 6,577 1 View

How Metal oxide nanoparticles become smart materials?

How Metal oxide nanoparticles become smart materials? example: thermochromic nanoparticles= smart.

01 January 1970 3,336 3 View

How two melting peaks in DSC of polypropylene can be merged into one crystallization peak?

The figure shows DSC cooling (blue) and 2nd heating (green) curves (step: 10 K/min) for a commercial sample supplied as Atactic Polypropylene (APP). The heating curve illustrates two major...

03 March 2021 5,857 3 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

Which fluorescent dye to use for measuring total ROS production?

Is DCFDA appropriate for measuring total ROS production, or can it only detect certain types of ROS? If I want to measure total ROS production, which dye should I use?

01 March 2021 9,447 3 View

What do I do with DLS peaks that are from the buffer?

I'm looking at the aggregation of my protein sample using DLS. Unfortunately, my buffer (20mM HEPES) also results in a set of peaks. These are at approximately 1 and 1000 d.nm. The lowest peak...

01 March 2021 9,015 2 View

Is there anyone who experienced with cytotoxic effect of Hoescht 33342 dye?

Is Hoechst toxic to cells? In general, it is known as non-toxic. I am working with dsRED MDA-MB-231 cell line. I applied it for my PDMS-based microfluidic platform, for this reason, I incubated...

26 February 2021 9,119 3 View

What information can be had from raman at higher wavenumber?

i have recorded raman spectra of strontium oxide thin film. the spectra were recorded in the range 400 to 4000 cm-1. i have reference to peaks upto 1000cm-1. but i couldn't find literature for...

26 February 2021 2,499 1 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View

How can I find a Raman spectrum wavenumber corresponding to what compound?

I have several Raman spectra with very distinct peaks at certain wavenumbers, such as 277, 359, 466, 583, 623, 686, and 795cm-1. How can I identify them to what compound(s)? The RRUFF and others...

24 February 2021 363 3 View

What condition required for coating of Fe3O4@SiO2 by using APTES?

I tried coating Fe3O4@ SiO2 by using APTES in 5% water-ethanol but it is not coated. Kindly suggest a solution for it. Thanks

24 February 2021 5,992 4 View

Genescan gives 3 peaks instead of one?

Hi all, I am doing a genescan analysis for a deleted exon in the patient sample. The amplified region is 215 bp. In the patient sample because of homozygous deletion, no peak is observed while in...

23 February 2021 5,645 1 View