What was the reason to break the Tan (delta) curve ? - FAQS.TIPS

Janitha Jeewantha @Janitha-Jeewantha

09 May 2020 0 1K Report

Hi,

Please refer attached DMA test result for Bisphenol A based neat sample. The dimension of the specimen was 8mm width and 2 mm thick.

Why Storage modulus curve is not tending to flat?

What was the reason to break the Tan (delta) curve?

Appreciate your comments and suggestions.

Regards,

Janitha.

Badges
Science method

Similar topics
Biological Science
Ecology

More Janitha Jeewantha's questions See All

Can someone help me to find Q1 & Q2 Journals please?

My research area is “influence of technological advancements in fashion retail physical interior stores” need to find literature relating to this from Q1 and Q2 journals. Can someone help me, please?

11 March 2024 1,826 0 View

Which instrument is suitable for measure intrinsic viscosity (IV) of PET ?

Which instrument is suitable for measure intrinsic viscosity (IV) of PET ?

27 September 2023 9,304 0 View

Constrained strain, Stress recovery ?

Hello, Is it possible to run constrain strain, stress recovery through Discovery HR-2 (TA Instruments). Please advice me. Thank You, Janitha.

03 September 2021 1,440 0 View

I want to have a agar disk diffusion assay for antimicrobial compounds. E coli is the target organism . How much E coli do I need to plate out?

In agar diffusion assay, how I determine the no of microorganism that need to plate out to carryout assay.

02 July 2021 8,910 2 View

After chromatographic separation, does it need to evaporate mobile phase in order carryout bioassay and NMR?

I going to check the bioactivities of plant extracts

20 June 2021 9,685 9 View

Can you suggest a method to isolate compounds from plant extract and to determine their structure ?

I have a plant extract and I want to isolate metabolites present in it. Which chromatographic method and spectroscopy will be ideal for this

14 June 2021 8,273 18 View

Hi, Can you suggest a suitable spectroscopic technique to elucidate structure of metabolite molecule?

I want to determine the structure of extracellular metabolite of plant extract

14 June 2021 1,761 18 View

What is the significant difference beween two DSC curves?

Dear All, The bisphenol A based epoxy was cured under two curing cycles (curing cycle I and curing cycle II). After that, conducted a DSC experiment, and the results attached herewith. Why both...

02 May 2021 9,280 4 View

Dynamic mechanical analyser (DMA) test standards ?

Hello, I found that many researchers used, different settings (Heating rate, frequency, thickness… etc.) in DMA testings. To obtain glass transition temperature(Tg), what is the standard we...

27 September 2019 9,846 5 View

What is the alternate option for multipile linear regression analysis in a cross sectional study?

i want to assess the associations between the independent and outcome variable by using multiple linear regression model. Is there any alternate to this?

17 July 2017 5,193 2 View

Similar questions and discussions

Does crude extraction using NaOH and Tris work well with Fungi?

I'm trying to find a DNA extraction method for fungi that does not require equipment and heating. Is there anyone who can suggest an alternative option? Thank you

08 August 2024 4,733 2 View

Does the delta function actually make sense to use on point particles?

The delta function seems produce logical contradictions when analyzed on a fundamental level. I would be curious if anyone else agrees.

31 July 2024 10,109 3 View

How to find a reaction is reversible or irreversible in CV? How to know the number of electrons transfer?

My screen printed electrode CV is given here. For Nerstean one electron reaction the delta E value should be close to 57 mV and ration of Ic/Ia should be close to 1. I did CV of my screen printed...

30 July 2024 4,671 3 View

Please investigate the effect of temperature and strain rate of hot deformation and the formation of delta ferrite in martensitic stainless steel 410?

Please investigate the effect of temperature and strain rate of hot deformation and the formation of delta ferrite in martensitic stainless steel 410?

25 July 2024 9,408 0 View

Convergence criteria not met but ends with normal termination. Could not open the log file in gaussview. How to rectify this problem?

>>>>>>>>>> Convergence criterion not met. SCF Done: E(RB3LYP) = -472.437545326 A.U. after 33 cycles NFock= 32 Conv=0.29D-07 -V/T= 2.2914...

16 July 2024 8,862 2 View

Not able to give GAFF forcefield to my ligand?

I have been able to assign the CHARMM forcefield to my ligand i.e. acetyl coenzyme A but not the amber forcefield. I want to run amber forcefield and the parameterization of ligand is failing. I...

15 July 2024 7,323 1 View

How does that stream's gradient change downstream as it enter the alluvial fan and difference between an alluvial plain and a delta plain?

How does that stream's gradient change downstream as it enter the alluvial fan and difference between an alluvial plain and a delta plain?

12 July 2024 7,337 0 View

How to improve my plaque assay for influenza virus?

I used MDCK cells for my plaque assay for influenza virus and seeded 950,000cells/well in 6-well two days before infection. The virus was diluted in FBS-free MEM with 0.5ug/ml TPCK-trypsin. Here...

11 July 2024 5,669 5 View

How to reduce the material coming out of the torque rheometer?

A physical mix was in vitro evaluated on a torque rheometer. The composition was predominantly recycled polypropylene (PP), yet the melt flow index (MFI) was found to be excessively high....

25 June 2024 10,154 0 View

What is the best way to synthesize cDNA of miRNA; using poly A kit or stem loop PCR?

Recently, I have been trying to quantify the expression of miRNA. I have extracted the miRNA. However, I am not clear about using the cDNA synthesis kit usually there are two kits providing by...

16 June 2024 9,723 2 View