03 September 2022 0 4K Report

Hello,

I am facing this issue with the IPO where it is taking a lot of time to complete the iteration. The files which we are using are acquired on Thermo Orbitrap Fusion coupled with Dionex Ultimate 3000 RS. Six QC files, each of size 110,603 KB approximately, were loaded for parameter optimization. Usually, it takes 24 hours for optimizing the peak picking parameters, but here it is taking a lot of time (around 3 days), and still, it keeps on running.

We are not able to figure out what the problem is. Kindly help me out!

Thank you!

More Arpita Singh's questions See All
Similar questions and discussions