What should be the physically acceptable range of active mass of a supercapacitor electrode?
As specific capacitance depends on mass so whether a mass in the range of micro-gram is physically acceptable?
Active mass in the range of microgram is acceptable when your electrode is completely covered by the active material. Nevertheless, the active mass would depend on the area of the electrode also.
Is 5-10 microgram is OK?
Please tell which open source software is best to draw flow charts diagram for research paper.
11 December 2014 3,222 4 View
10 November 2014 7,790 4 View
I have read a few papers where the vacuum filtration is employed to fabricate GO membrane. Here the concentration is an important parameter . I am unable to find any direct relation between...
08 September 2014 6,399 1 View
Minimum thickness of Graphene film to replace ITO.
08 September 2014 9,942 5 View
WS2 has a special property that in bulk form it is an indirect band gap semiconductor where as if we consider monolayer or a few layer then it is direct band gap semiconductor. The room...
08 September 2013 6,552 2 View
I am using a Sutter electrode holder for my patch clamp experiments, but I'm having trouble keeping positive pressure inside my electrode due to a leak out of the back of the holder. I have added...
02 March 2021 5,829 1 View
I want to do RF sputtering of ITO on glass substrate using magnetron sputtering. what thickness do i need to make it good conductive layer to use it for PSC. Moreover, whats about thickness of...
01 March 2021 395 3 View
I am conducting anodic electrodeposition of MnO2 onto a stainless steel substrate, using a platinum strip as a counter electrode. This is done galvanostatically, with the current held between 5...
27 February 2021 1,829 3 View
During performing CV of a GCE or modified GCE, we rise the potential in the first half of the cycle and reduce it in reverse half. During the first half, what is the nature of charge on GCE or...
25 February 2021 7,994 3 View
I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...
23 February 2021 9,592 2 View
What are the testing rate for electrodes recommended by ASTM for cochlear implants. I am currently doing the 15mm/min elongatio testing.
22 February 2021 1,515 1 View
One of my colleagues said, "the impedance you can measure with the three electrodes and with the specific sequence varying the frequency" Is it possible to configure the potenciostat without the...
21 February 2021 418 2 View
Hello everyone Do you have any information about this error 'The experiment was stopped by a potential overload on Vs (auxiliary electrode)' in Origamaster software? I tried everything possible,...
19 February 2021 3,152 7 View
The experiment is really simple. When I do a bulk electrolysis with 1% TFAA (ACN solution) to get dihydrogen, what is going to be oxidized? (working electrode graphit, counter electrode platinum,...
18 February 2021 4,430 1 View
I am working on cathode material. I have made different Li-ion coin cell against Li metal using commercial available cathode materials such as LCO,LMO, LFP and NMC and also with the lab...
18 February 2021 1,450 3 View