How to define the sink temperature and film coefficient?

Hi, everyone. I am considering the heat conviction during compacting simulation by Abaqus. I was wondering that how to define the sink temperature and film coefficient? Is there any references...

21 February 2021 6,197 1 View

Can RNAscope be used to quantify the mRNA expression level of certain genes?

Hello, all, I want to explore the mRNA expression level of certain genes in the brain under physiological and pathological conditions. In previous studies, the researchers usually isolated the...

18 February 2021 1,518 1 View

How to define thermal failure in Abaqus?

Hi, everyone, I am simulate the impacting CFRP model, I want to know how to define thermal failure during the impact process because epoxy degraded owing to thermal effects. Thank you so much for...

25 December 2020 7,424 3 View

How to define thermal conductance in Abqsus?

25 December 2020 3,596 1 View

ESA Eureca spacecraft Solar Array Arcing demage, What is the cause of the problem?

We see a photos of solar array damage suffered by the ESA Eureca spacecraft that was recovered by the Space Shuttle. photo shows a sustained arc site on its solar arrays. In this case, the...

23 December 2020 2,512 2 View

Micro-scale unit in Abaqus?

Micro-scale unit in Abaqus. Hi everyone, I am working on micro-scale simulations, the length of the model is micrometers. So, some information is provided on the internet, but some part is...

10 December 2020 8,448 3 View

How to reduce background noise when testing cholesterol level in rat serum?

l've got rat serum samples with different background (from pink to yellow) and l'm trying to test total cholesterol, HDL and triglyceride in mice serum. l'm worried that the background noise...

14 November 2020 6,628 3 View

Is Uniform Convergence property contradictory to No Free Lunch Theorem?

In Statistical Learning Theory, Uniform convergence means for a hypothesis class H, given m(\delta, \epsilon), for arbitrary distribution over domain (X, Y), with probability $1- \delta$, the...

03 November 2020 7,732 5 View

How to recognize and verify the crystallization occur or not?

Hi, everyone My feedstock powder is water atomized Sn with a diameter range from 10-100 um. After the cold spray processing, the EBSD maps can be obtained. Because my smallest powder is 10um,...

07 September 2020 7,766 4 View

What is we need for Sequence learning (Speech, NLP, Finance, Transportation and so on)?

In 2017, a famous paper proposes Transformer which successfully adopt self attention as well as FFN for NLP. The paper is called "Attention is All You Need". This work lets many scholars know RNN...

11 August 2020 8,119 11 View

How two melting peaks in DSC of polypropylene can be merged into one crystallization peak?

The figure shows DSC cooling (blue) and 2nd heating (green) curves (step: 10 K/min) for a commercial sample supplied as Atactic Polypropylene (APP). The heating curve illustrates two major...

03 March 2021 5,857 3 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

What do I do with DLS peaks that are from the buffer?

I'm looking at the aggregation of my protein sample using DLS. Unfortunately, my buffer (20mM HEPES) also results in a set of peaks. These are at approximately 1 and 1000 d.nm. The lowest peak...

01 March 2021 9,015 2 View

Why initial concentration of Pb not the same as calculated one when testing using AAS?

I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...

26 February 2021 9,580 4 View

What information can be had from raman at higher wavenumber?

i have recorded raman spectra of strontium oxide thin film. the spectra were recorded in the range 400 to 4000 cm-1. i have reference to peaks upto 1000cm-1. but i couldn't find literature for...

26 February 2021 2,499 1 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View

How can I find a Raman spectrum wavenumber corresponding to what compound?

I have several Raman spectra with very distinct peaks at certain wavenumbers, such as 277, 359, 466, 583, 623, 686, and 795cm-1. How can I identify them to what compound(s)? The RRUFF and others...

24 February 2021 363 3 View

Genescan gives 3 peaks instead of one?

Hi all, I am doing a genescan analysis for a deleted exon in the patient sample. The amplified region is 215 bp. In the patient sample because of homozygous deletion, no peak is observed while in...

23 February 2021 5,645 1 View

Is this the write procedure for acid digestion of soil for heavy metal analysis using AAS?

How to do acid digestion of soil sample with 3:1 aquaregia in an open vessel?

23 February 2021 3,053 7 View