What is the routine total body absorbed dose in diagnostic nuclear medicine?

Saeed Shanehsazzadeh @Saeed_Shanehsazzadeh

10 October 2014 1 724 Report

Dear All,

Do you have any published data about total or whole body absorbed dose in diagnostic nuclear medicine?

What is the the maximum permissible dose of diagnostic nuclear medicine?

Saeed Shanehsazzadeh

There is a website, but I need more:

http://hps.org/hpspublications/articles/dosesfrommedicalradiation.html

Badges
Science topic

More Saeed Shanehsazzadeh's questions See All

When do they stop scientific sanctions against Iran?

It has happen many times, when one of our colleagues submit a manuscript in an ISI Journal This time, after 2 months post submission I received an email: Dear Dr. Shanehsazzadeh: I write you in...

04 May 2015 4,465 1 View

Do you know which nanoparticles currently use in clinical trials or clinics?

I need a list of nanoparticles in clinincs

11 December 2014 7,761 5 View

Where can I find mice organ weights?

Dear All, I need a complete data about mouse organ weights (different types of mice) I appreciated if you help me.

11 December 2014 5,814 4 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to upload pdf of my articles published?

03 March 2021 2,183 3 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

How to code open-ended questions in SPSS?

Hello all, In SPSS I am going to code 2 open-ended questions. I have already read all the answers and I made a list of the most important categories to which I can code the answers. This question...

02 March 2021 1,757 4 View

How do I determine the degree of polymerization of PEG 400 based on NMR integration?

Hello, I am working on the photocatalytic degradation of PEG 400. I would like to know if it's possible to determine the degree on polymerization based on NMR integration, or by the MW of the...

02 March 2021 6,186 3 View

Would adding books published in Lambert Publishers increase my RG impact?

There are some books published in LAP. Shall I add it to the RG?

02 March 2021 2,753 1 View

Which cell line should we use to perform biological dosimetry experiments?

We are preparing some experiments based on irradiating cells under different conditions in order to evaluate the effects in terms of DNA damage, genetic expression, etc. As our project is...

01 March 2021 3,355 3 View

Is Journal of Agricultural Research a predator?

it is published by Juniper

28 February 2021 354 4 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

How can I publish a manuscript in free or low cost journal with good H-Index?

Dear all I am going to publish my manuscript which is from my thesis in a good H-Index journal but I found them very expensive(I don't have financial support) based on the exchange currency of my...

28 February 2021 7,800 6 View