What is the percent of imaging guided PCI in your cath lab to total cases ?

More Amir Khalifa's questions See All

How to model Supercritical water gasification (SCWG) process in Homer software?

Hi everyone How to model Supercritical water gasification (SCWG) process in Homer software?

25 February 2021 4,075 1 View

Is it possible to define biogas as a fuel in the reformer process(scwg) in Homer software?

Hi every one Is it possible to define biogas as a fuel in the reformer process(scwg) in Homer software? Biogas fuel is not available in the options thanks

23 February 2021 6,518 3 View

How T cells recognise non-peptide antigens?

This might sound very basic question, but please share with me an explanation of how the T cell is activated when the antigen is not a peptide? What happens? And what are the molecules involved in...

21 February 2021 564 3 View

How can I measure the surface interaction or surface interfacial chemistry between polishing abrasives and upper surface of substrate ?

I am working on polishing abrasives. I need to do few characterizations ? which can provide the on time surface chemistry of substrate with polishing abrasive during optical polishing. I would...

18 February 2021 5,319 3 View

Which CGRP I could use to treat murine cells in vitro?

Does anyone worked with CGRP on mice. I m stuck with which the product good to use. I found Sigma products are good but Sigma has a lot of CGRP products and papers didnt mention the code or cat#...

16 February 2021 8,344 2 View

How can I find the thermophysical properties of high temperature microencapsulated phase change materials (MPCM)?

Hi everyone. I am looking for a high temperature MPCM. More specifically, I need the thermo physical properties of a microencapsulated phase change material with the melting temperature between...

14 February 2021 3,606 2 View

Can explain this diagram to me, is this the average consumption curve for one day or the total consumption of days in a month summed up in specific?

The hourly load curves of the selected household in each season are shown in Fig. 28. Figure 28 shows the demand for electricity in four months on an hourly basis. Can you explain this diagram to...

08 February 2021 657 16 View

What are the causes of hyphae granulation?

Greetings, The examination of the interaction zone between Fusarium oxysporum and Pseudomonas by light microscope revealed clear hyphae without septa and the presence of granulations (vesicles),...

05 February 2021 5,523 4 View

How to conduct mesh sensitivity/convergence analysis in MSC Marc Mentat?

Currently using Msc Marc Mentat for FEA. Now i conduct the mesh convergence/sensitivity analysis manually. So I need to know if there any automatic way to conduct the mesh convergence/sensitivity...

04 February 2021 3,310 3 View

Why VASP MD Crashes with ALGO = Fast ?

Hi, I'm doing molecular dynamics on a 168 atoms system with a 20 A vacuum. To speed up my calculations, I set ALGO = Fast tag in INCAR, but surprisingly VASP crashes momentarily!. I have done a...

25 January 2021 9,876 3 View

DNA isolation from small amounts of cells (3000-100000) sorted by flow cytometry?

What do you think, what method of DNA isolation from a small number of cells is the best choice for obtaining maximum yield and good quality (260/280>1.8)? I have tried DNAeasy, MicroKit...

11 December 2019 2,916 3 View

Why recovery of Mtb DNA is low?

Hi all, I am trying to isolate DNA from Mtb and I have been following two protocols: 1 ml liquid culture, spin and discard supernatent, dissolve pellet in 1X TE, heat at 80 degree Celsius for 15...

09 October 2019 3,148 2 View

Phenol-chloroform-isoamyl problem?

This is my first time using commercialised PCI (25:24:1) solution. After adding equal amount of PCI into my supernatant, two of my samples did not form two layers as they should be. After...

08 September 2019 4,855 3 View

Phenol-chloroform-isoamyl problem?

This is my first time using commercialised PCI (25:24:1) solution. After adding equal amount of PCI into my supernatant, two of my samples did not form two layers as they should be. After...

03 September 2019 9,596 3 View

Any suggestions on the best way to extract DNA from neonate snake scale clips?

We are attempting to extract DNA from Crotalus adamanteus via PCI extraction. After spec-ing on nanodrop, we noticed the neonate samples had significantly lower DNA concentrations compared to the...

31 December 2018 9,963 5 View

50Hz and 100Hz harmonics in low noise transimpedance amplifier increase with DUT current and capacitance?

I've built a low noise transimpedance amplifier (TIA) to measure low frequency noise in semiconductor devices. The amplifier is connected to a triaxial prove station, supplied with +/- 7.8V using...

05 June 2018 9,771 4 View

Compatibility Significant to Behavioral Intention, so what can i do?

Hi, i am doing research in technology adoption using PCI model by Moore and Benbasat. The technology that i observe is travel booking application. From my research, it is known that compatibility...

05 June 2018 5,728 0 View

Any one pleas help me in Using PCI Geomatica 2017 crack for lineament extraction?

I downloaded PCI Geomatic 2017 x64 with data and installed in my laptop Core I5 processor 1.6GH and 2.3 GHZ,8GB RAM and 1TB storage. I installed with no problems,but while execution of the...

01 February 2018 543 2 View

Phenol chloroform extraction sample ratios?

I am performing a gDNA extraction for sgRNA sequencing and to maintain representation I am required to use large sample size (around 30e6 cells/sample). I have tried some kits that suppose to...

31 December 2017 3,182 3 View

Can anyone suggest me modification/s or method of DNA extraction from sediments of estuary?

I have been trying to extract DNA with no success. I have used following methods 1. PCI method with and without bead beating 2. kit methods qiagen, himedia 3. interchange of reagents 4. cold and...

11 December 2017 7,805 4 View

Chaudhury Meshkat Ahmed

Dear Amir Khalifa,

We do not have IVUS or OCT in our cath labs. We have 2 coronary dedicated cath lab, where around 100 PCI, including PCI in LMCA beings performed. All most no cases of LM bifurcation lesion done.

Kamal Pasha

We have IVUS, which is used in 5-10% cases only. LM bifurcation, ostial LAD, to see sent apposition (esp. calcified lesions) etc.

Nobuhito Yagi

We have IVUS, and OFDI which is used in almost 100%(90% IVUS and 10% OFDI) cases, Including ACS situation.

Khaled Leon

We have IVUS, and irs dedicayed to LMCA intrrventions mainly, due to cost issues, so its in the range of 5% or so.