I tried to input my motion data into Quake/W which is obtained from PEER database that scaled already, when I input it into the program, it becomes skipped without any notice. the analysis says solved but there is no results appear or even deformed mesh. and then I tried to input other motions from example file from Geostudio, and the runs are success, then I discovered that the problem is in my input motion, but I don't know what is wrong it. If you have any idea about this problem, please give me some explanations. Thank you so much
Hello Yayat Kusumahadi, i am working on Qwake/w too. but i donot have motion data. will you please send me that file. it will be very helpful.
Thanks.
Email: [email protected]
Hi mas Yayat
I've ever faced the same problem like this when i used another dynamic analysis program. It can be due to the iteration process is not completed. Sometimes, if the ground motion duration exceeds the limit of the maximum ground motion duration, the process would not work correctly. So, I suggest you to cut the unnecessary ground motion duration in your input motion, for example in the beginning and in the end. Sometime, numerical program has limited total number of ground motion duration that can be input. Therefore, you should cut or adjust the time step of your ground motion.
Good luck
- Badges
- Science topic
- Similar topics
- Biological Science
- Kinesiology
- Running