How can I write equality constraints in COMSOL 5.2?

I have a heat transfer optimization problem. My heat transfer area is governed by a quadratic equation in two variables as follows which is to be supplied as a...

09 October 2018 4,284 5 View

What are the methods used for recording initiation of combustion?

When high speed camera and schlieren phtography is not available, what are the possible methods that one can use for recording initiation of combustion? We can use photodiodes with a small quartz...

01 February 2015 6,361 7 View

Is the knowledge of impact mechanics applied to the diagnosis of brain trauma?

I am a Mechanical Engineer studying Biomechanics of traumatic brain injuries. I wanted to know if there is any classification which may aid the diagnosis of brain injuries based on the type of...

09 October 2014 5,622 4 View

I am enrolled in a pg course in mechanical engineering. Are there any universities offering a summer research fellowship for graduates in India or els...

I am enrolled in a pg course in mechanical engineering. Are there any universities offering a summer research fellowship for graduates in India or elsewhere. If anyone can give any info about how...

09 October 2011 8,799 0 View

How to repeat an operation on an atom selection for multiple times in PyMol?

Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...

02 March 2021 4,569 4 View

What analysis to choose with a large neste dataset and clearly skewed or kurtotic distributions?

Hello! I have a dataset of n=3000 nested within 8 countries with approximately 200 or 400 responses in each country. I originally planned to perform multilevel modelling with 4 dependent variables...

02 March 2021 6,865 1 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

How to plot the probability paper of Gumbel distribution using R programing?

In R-studio, there are many commands of Gumbel package. Arguments are also different. I`m asking about the alpha parameter of the Copula which must be greater than 1. If this is the one used to...

25 February 2021 5,229 3 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

Unknown debris sheets observed in cell culture flasks?

Hi, We culture neural progenitor cells in T175 culture flasks coated with PLO-Laminin. We have successfully grown these cells with our protocol for months. Recently, we observed large sheets...

25 February 2021 3,443 4 View

Can cells be reused after using WST 8/ CCK 8 from Sigma Aldrich?

Hi all, Can cells be reused after I have seed them onto 96 well plates and test them with cell counting kit at OD450 (CCK8) at 12 hours, wash them with PBS x3 and add new media and let them...

24 February 2021 5,072 1 View

Are there methods for automatically mapping floodplains, fans and terraces?

I want to map these river geoforms with as little subjectivity as possible. I have a high resolution DEM generated by drone data.

22 February 2021 7,800 3 View

No title

22 February 2021 9,932 11 View