What is the influence of fiber substrate on perovskite alignment and work function?

16 May 2023 0 3K Report

how does the charge carrier density of the semiconductor align the substrate and perovskite fermi levels for band bending to occur inside the perovskite layer? how much of the charge density ensures this?

is this only restricted to planar PSCs or even one-dimensional fiber-based PSCs?

Badges
Science topic

Similar topics
Correction

More Tonny Kakooza's questions See All

What is the mass% and mole% of water in the 11ml solution?

34ml ethanol+ 3ml Methanol+ 75 ml water = 112ml solution in a beaker I’ve taken 11ml solution in another beaker. What is the mass% and mole% of water in the 11ml solution? can anyone give me the...

10 January 2021 359 2 View

Is transitional justice possible within the context of statelessness?

My project focuses on the Rohingya in Myanmar,who are victims of gross human rights violations. Since they are not considered as citizens of Myanmar and Bangladesh,i am looking for the most viable...

02 April 2020 3,040 0 View

Which brief adult attachment measures do you use?

Which brief adult attachment measures (less than 10 items) exists with good psychometrics.

05 September 2015 2,213 5 View

Design and analysis of a unsupported cut slope

what are the possible methodologies used in the design and analysis of a cut slope

01 January 1970 329 2 View

What is the ionic radius of Hydrogen anion? And how to know the exact ionic radii of the elements?

I'm trying to calculate the tolerance factors of the hydride perovskite and the value calculated by me and the reported values are contradictory. Need more clarity in using the correct ionic radii...

01 August 2024 2,614 1 View

I want to know where can i find n , k mesoporous peroviskite coefficients?

in this link refractiveindex.info i didnt find i work on a simulation comsol of mesoporous perovskite i want to know the properties optoelectric and n,k coff

09 June 2024 2,071 4 View

How do we find Raman's active mode in the Pna21 space group with the C2v Point group at PARTICULAR WAVE NUMBER?

for the Perovskite material

03 June 2024 1,027 1 View

Laser for perovskite module?

Hi, I'd like to know if someone knows about a company where I can buy an affordable laser-scriber for perovskite films and another thin film for the fabrication of modules. Many thanks,

31 May 2024 2,841 0 View

How measure tolerance factor of BaSrCaTiO3 perovskite?

for ABO3 if only A & B then we used t=rA+Ro/sqrt2(rB+rO) kindly explain for BaSrCaTiO3 ?

31 May 2024 2,036 0 View

Is it necessery to have all the layers of an all-inorganic perovskite solar cell is inorganic, or only the active layer should be all-inorganic?

What should the requirement be for an all-inorganic perovskite solar cell? What should be the nature of its layer? If we use any organic layer in an all-inorganic perovskite active material-based...

24 May 2024 3,355 2 View

How to parallelize "Phonon Dispersion" Calculation in QE v7.2?

I am trying to perform ph.x calculations on lead-halide perovskite primitive cell with `8 8 8` k points in scf calculation and `6 6 6` q -point grid. The calculation is computationally expensive...

12 May 2024 6,276 0 View

How to increase the short circuit current density (Jsc) in a Cs0.15FA0.85Pbi3 perovskite photodetector?

Hello guys, I am optimizing a perovskite photodetector device with the device structure ITO/PTAA/Cs0.15FA0.85PbI3/PCBM/BCP/Ag. PTAA (2 mg/mL): 5000 rpm/30 sec Perovskite (1.3 M): 1000 rpm/10...

10 May 2024 2,297 0 View

How the EQE of a p-i-n perovskite photodiode can increase with reverse bias?

In this article Interface engineering for gain perovskite photodetectors wit... shows under -5V, obtained EQE 140000%. How does EQE obtain over 100%, any equation related to this?

09 May 2024 8,171 0 View

What is the standard way of deposition of MoO3 and Ag by thermal evaporation?

Dear friends, I am trying to develop an efficient n-i-p structure device (perovskite, colloidal quantum dots, organic solar cell). Many researchers widely use MoO3 and Ag as metal electrodes in...

05 May 2024 8,814 4 View