What is the formula to calculate proportion percentages in composites?

More Mohammed Rizwan Ali's questions See All

Which test is suitable for knowing the mixed proportions of polymer in a Polymer-Polymer blend?

suggest the method of knowing the percentage of polymer in polymer -polymer composite.

06 July 2018 9,144 3 View

Which surfactant chemical is a suitable for dispersing iron powders in to ABS polymer?

I want to know about the surfactant chemicals used in polymer processing

07 August 2016 7,501 2 View

How to define an anisotropic material with asymmetric elastic compliance/stiffness matrix in ANSYS APDL?

I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...

09 August 2024 5,048 2 View

Is it possible to plot the atom-projected band structure using GPAW?

Hi, I'm currently working on a project where I need to plot the atom-projected band structure using GPAW. I've been able to calculate the band structure for my material, but I'm having trouble...

07 August 2024 269 3 View

Please explain how the plastic input value should be considered from the true stress-strain curve for the bilinear elastoplastic material model ?

I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...

05 August 2024 454 3 View

Do you know best conditions for formation of best REE deposits?

I want to know more about REE deposits.

03 August 2024 6,930 2 View

What is the best conditions for formation of REE ore deposits?

I want to know more about REE deposits.

31 July 2024 7,366 1 View

How Can I Apply Hashin Damage Properties to Solid Elements in Abaqus Without Using VUMAT?

Sure, here is the translation: I have a 3D orthogonal woven composite structure where warp, weft, and binder yarns are oriented in three directions. After modeling these yarns and the matrix in...

28 July 2024 8,169 0 View

Why Orca calculations take too loong?

Hello! I am trying to calculate the sumatriptan molecule, but it has been counting for five days and it does not stop. It seems to me that it is too long and I am doing something wrong. Please...

25 July 2024 3,364 5 View

MDCI module in Orca software?

Dear Researchers, My question is associated with the "MDCI" method in Orca. Please let me clarify my question using a simple example: Suppose we are going to perform CBS extrapolation using "!...

21 July 2024 1,632 0 View

Should a defect induced structure be optimized in a DFT calculation?

I'm trying to study the effects of introducing vacancy defects in my material. If I optimize my structure and find the lattice parameter before introducing vacancy, should I again optimize my...

18 July 2024 1,794 2 View

What could be the possible reason that sintering of polycrystalline diamond fabricated with tape casting has suddenly started failing?

I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...

16 July 2024 3,212 5 View

Carlos Araújo Queiroz

Please check the following discussion for its possible help: https://www.researchgate.net/post/How_might_I_determine_glass_fiber_content_in_composite

Mohamed Gadallah

Hello Dear

The following link may be help you

https://math.wonderhowto.com/how-to/calculate-percentage-composition-by-formula-301932/

Mohammed Rizwan Ali

Thank u for ur precious reply