What is the exact reaction mechanism for cobalt ferrite material as a working electrode in KOH electrolytic solution for supercapacitor application?

06 January 2021 0 4K Report

What is the exact reaction mechanism while using cobalt ferrite material as a working electrode for supercapacitor application in KOH electrolytic solution? Which reactions takes place at different potential values and how these reactions contribute towards capacitance?

Badges
Science topic

More Shamal Shingte's questions See All

Why the CV of Activated Carbon (AC) deposited on Nickel foam is showing redox peaks instead of rectangular shape in KOH electrolyte?

I have used 90% Activated Carbon (AC), 10 % PVDF as a binder, and NMP as a solvent to prepare a thin film of AC on Nickel foam. Nickel Foam is cleaned with detergent, ethanol, HCl, isopropanol and...

15 October 2023 3,311 13 View

Why solution resistance ( Rs ) measured in the same electrolyte is different for the same material prepared at different conditions?

I am measuring solution resitance (Rs) of ferrite thin films annealed at different temperatures. EIS measurements are carried out using metrohm autolab instrument using 3 electrode system (Counter...

25 October 2022 8,966 0 View

How to increase the wettability of platinum coated silicon substrate for thin film deposition?

I am trying to deposit a thin film of ferrite on a platinum coated silicon substrate by a dip coating method. But when the substrate is being pulled out of the solution, whole deposited layer...

22 December 2021 9,903 12 View

How to get mesoporous cobalt ferrite thin film on Pt/Si substrate by electrodeposition method?

We want to deposit a thin film of mesoporous cobalt ferrite using a surfactant on Pt coated Si substrate by electrodeposition. What is the procedure for it? Does KLE polymer useful for this procedure?

10 January 2021 655 10 View

How possible is it to talk about ethnic identity formation in a divided society using Spivak ''Strategic Essentialism' as a theoretical framework?

Postcolonialism theory, Identity formation

18 September 2014 2,066 6 View

Why specific capacitance is not proportional with the specific surface area?

Dear researchers, Why specific capacitance is not proportional to the specific surface area? I have material A with a surface area higher than material B, but material B is showing little bit...

26 July 2024 9,156 2 View

How to saturate steel samples with hydrogen?

I have tried to saturate ferritic steel with hydrogen using the electrolytic method and H2SO4. However, the effect was very poor even after 3 days of "saturation". Can anybody help in choosing a...

24 July 2024 4,393 2 View

Issues in coating of cathode material on Al foil, why we are not getting proper coating and results when the cathode was coated on Al-foil..?

We are trying to coat some cathode materials on Al-foil ( ex - LiFePO4 , S@CNT, etc). When we coated the Al foil with the cathode (ex - S@CNT) material , the cycling result was annoying. But the...

09 July 2024 5,123 4 View

Does the specific capacitance value decrease or increase over time?

Will these measurement results change, for example, 1 month after the first measurement (e.g. CV, EIS) of the electrode or supercapacitor device? If it changes, how will it change? Is there an...

03 July 2024 3,644 2 View

What is the capacitance of Glassy carbon electrode?

I need to calculate the time constant which requires the capacitance of the glassy carbon electrode.

01 July 2024 1,087 2 View

Which light source should be used for photocatalytic water splitting?

I'm working on photocatalytic water splitting and the material is ferrite. The absorption edge of the material is at 700 nm. So which lamp should I use? halogen lamp or Xenon light source?

24 June 2024 6,832 5 View

Self discharge of freshly made NMC half cells and voltage stabilizes at 3.3-3.5 V vs Li/Li+ during charging. What can affect it?

I am making Li half cells using NMC as cathode. The OCV is around 3 V but it self discharges and during charging the voltage increases to 3.5 V and then drops to 3.3-3.4 V and stays there. I have...

23 June 2024 842 3 View

What does the area under the curve signify in dielectric loss tangent studies for solid polymer electrolyte ?

In solid ceramic electrolyte what is the Physical significant of area under the curve in dielectric loss tangent studies ??

23 June 2024 4,354 1 View

How to predict the efficiency of a very low speed Railgun Actuator/Lorentz Force Actuator?

I'm not an electrical engineer or anything related to that subject, so my apologies if I understood something incorrectly. Well, I read somewhere that the slower the railgun is, the higher its...

23 June 2024 1,082 0 View

Can EBSD distinguish BCT martensite from BCC ferrite? Both have different symmetries, space groups but same lattice positions??

Electron back scattered diffraction is a versatile tool for micro-structure and micro-texture analysis of a variety of materials e.g., metals/alloys, rocks, meteorites etc., EBSD completely works...

18 June 2024 1,477 5 View