What is the diluent/solvent for STS-21 TiO2 solution?

Vytautas Kavaliūnas @Vytautas-Kavaliunas

28 February 2019 1 5K Report

I am working with STS-21 TiO2 solution. I need to reduce the viscosity. I am not sure which diluent or solvent to use. Any suggestions?

Isam Eldin Hussein Elgailani

Please look at the following below links which may help you in your analysis:

https://initiative-pro-titandioxid.de/wp-content/uploads/2018/02/Assessment-of-socio-economic-impacts-from-Carc-Cat-CLH-for-TiO2.pdf

Thanks

Badges
Science topic

Similar topics
Chemistry
Chemicals
Solvents

More Vytautas Kavaliūnas's questions See All

Ideality factor of Si diode less than 1?

In general, ideality factor ''n'' could be calculated by: n=(V2-V1)/ln(I2/I1) where voltage and current are taken from the dark I-V curve. For simple PN Si diode, it is close to 2. In my case NPNN...

23 June 2020 2,005 6 View

Which software is best for development of intersection origin-destination matrices from drone videos?

There are AI based software, such as swisstraffic to recognize vehicles and develope origin-destination matrices for intersections from videos. What is the best software in a field at your...

12 February 2020 4,477 0 View

Can anyone help to identify this small Heteroptera?

I suppose it belongs to Microphysidae family, Myrmedobia genus. I would be very thankful for any suggestion of identification key for this group? I found a lot of specimens of this species in the...

23 July 2017 9,687 25 View

Can anyone help to identify though to family these small Hymenoptera?

These insects I found in the litter of coniferous forests in Lithuania. They are very small ones, within 0.5 to 1 mm of body length.

21 August 2016 6,865 23 View

Is there an accurate way to simulate power consumption of ring oscillator in FPGA using Quartus software?

Is there a way to accurately simulate power consumption of a ring oscillator in Quartus ii?

09 December 2015 7,729 2 View

Could someone help to identify this ground beetle?

It was collected in Greece, 39°28'45.8868" N, 19°56'0.9888" E at 2 May, 2015. I suppose that it belong to Platyderus genus.

12 August 2015 7,853 7 View

Would someone know the descriptions of female genitalia of European Badister species?

Badister males are well distinguished , but females, especially Baudia subgenus, are mystical. Is it not?

09 November 2014 6,640 2 View

Is it safe to infuse Ringers solution ( which contains 5mmol/l potassium ) after kindey transplantation?

The first few hours after transplantation, when function of transplantate is unpredictable.

12 July 2013 9,577 0 View

Could anyone confirm that this specimen belongs to Meotica exilima (Staphyliniadae)?

The species of Meotica genus are problematic to identify correctly, so I need a help of experts of this group. I used the Muona (1991) as a quid for identification of this specimen. I was found...

01 January 1970 5,415 8 View

How dopants affects TiO2 photocatalysis efficiency?

I am working with Mg-, Cu-, Ni- doped TiO2. All of them achieves better efficiency when wt.% is lower than 1 %. Cu is in the first place, after that Mg and than Ni. Maybe some discussion will help...

01 January 1970 8,579 6 View

Ethylene glycol is newtonian or non newtonian fluid?

Some sources say it is treated as Newtonian as ethylene glycol has a higher viscosity than water, which affects the flow characteristics in simulations. But some also say it is non-Newtonian.

09 August 2024 2,111 2 View

What is the solvent for 8YSZ nano material?

I need to do some experiment with it in liquid form.

07 August 2024 613 3 View

Who of all of you will help TPEOM to re-originate the Earths atmosphere to it original 5 atmospheric elements/gases?

Global ‘Weather’ has stopped, as ‘aqua thermionic instituted by the ‘Global thermo atmospherics has instituted global thermodynamics of 120º C + and thus all waters are, or have boiled into a...

06 August 2024 8,716 0 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

Hello, regarding Mxene 2D titanium carbide?

I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.

02 August 2024 6,789 4 View

I need to dissolve stigmasterol for an animal experiment, it hasn't dissolved in either DMSO or vegetable oil. Can anyone recommend the best solvent?

Hello everyone, I need to dissolve stigmasterol for an animal experiment, but it hasn't dissolved in either DMSO or vegetable oil. Can anyone recommend the best solvent for stigmasterol?

01 August 2024 7,504 2 View

Ti6Al4V - Phase differentiation between alpha and alpha prime martensite?

Dear Researchers, Is it feasible to distinguish between alpha and alpha prime martensite in the Ti6Al4V alloy under rapid solidification in the as-cast state using XRD, in addition to...

30 July 2024 3,849 0 View

How to add viscosity into a hyperelastic material such as Mooney-Rivlin rubber in LS-DYNA?

Hi, I am working on a head FE model and want to try different material types on brain. I read some papers that use Mooney-Rivlin rubber model and wondering if i can add viscosity into it. Is it...

24 July 2024 5,908 0 View

Why methanol and sulphuric acid used in the analysis of polyhydroxyalkanoates (PHA) by GC-MS?

Why methanol and sulphuric acid, used in the analysis of polyhydroxyalkanoates (PHA) methyl esters by GC-MS? Additionally, why do we typically use non-polar solvents in GC-MS?

22 July 2024 1,210 2 View

When making abraxane with Nab tech, why is 9:1 Chloroform&EtOH used as solvents?

Is it the best optimization ratio based on experiments?

22 July 2024 8,170 0 View