What is are the different classifications of a tool changer?

I have roamed the internet trying to see the different types of tool changers available but I found no definitive answers, could you kindly help me?

02 February 2021 5,036 1 View

How to calculate covariance of Expectation Maximization Clustering?

I am working with MatLab R2017a, I have to implement EM clustering. But I am stuck with initialization of covariance in it. I have to calculate covariance using the dataset which is comprised of...

25 December 2020 4,620 3 View

MatLab code for Expected Maximization clustering of n-Dimensional data?

I need matlab code for expected maximization clustering of n-Dimensional data. I have searched and found code related to 1-D and 2-D. Can someone refer the code for n-D .

22 December 2020 5,110 3 View

Where can I find papers related to microstructure of inconel alloy 800?

I need to define the microstructure of inconel 800, but I cannot find any literature related to it. Literature is about incoloy 800 mostly which is a bit different. Can anyone tell me if there...

07 December 2020 3,137 3 View

Which software application is best for Anova analysis?

I want to perform "ANOVA" analysis of three different vegetation indices. anyone know how can i perform and which application /software are suitable for this. Thank you in advance.

16 November 2020 2,599 4 View

How can I specify the parameters for nano creep?

Which parameters should I employ for nano creep testing of Titanium and Inconel alloys? Should I load it with a constant load rate or strain rate? What should be the maximum load? What should be...

29 October 2020 5,727 4 View

How to find the elastic work using nanoindentation load depth curves?

I am using work of indentation approach to find out the values of hardness of Ti and Inconel alloys using nanoindentation load-depth curves. I can find the formula for total work. Whereas for...

13 October 2020 2,778 5 View

How to measure the volume of hydrogel?

08 October 2020 2,745 9 View

Why nickel oxide nanoparticles do not have single band gap?

band gap for nickel oxide nanoparticles is 3.85 to 3.45 eV

23 September 2020 260 4 View

How to Determine LD50 of a test compound by Lorke's Method if your mice (mus musculus) dies at the lowest concetration i.e. 10mg/kg?

I have used Lorke's method of determining LD50 of my test drug. The lowest dose according to this method is 10mg/kg and my mice died at this dose within the 30 minutes of IP injection. Does that...

22 September 2020 9,959 3 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to upload pdf of my articles published?

How to upload pdf of my articles published?

03 March 2021 2,183 3 View

Would adding books published in Lambert Publishers increase my RG impact?

There are some books published in LAP. Shall I add it to the RG?

02 March 2021 2,753 1 View

Is Journal of Agricultural Research a predator?

it is published by Juniper

28 February 2021 354 4 View

How can I publish a manuscript in free or low cost journal with good H-Index?

Dear all I am going to publish my manuscript which is from my thesis in a good H-Index journal but I found them very expensive(I don't have financial support) based on the exchange currency of my...

28 February 2021 7,800 6 View

Which software is better to write systematic review paper?

We have seen some authors use some software to write review paper. As obvious, the study of all published papers concerning our studying field is not possible and these software can help us to...

27 February 2021 6,296 1 View

Can I put a figure that was drawn by Bio-Render in publication paper?

I want to publish paper in journal but I have figures which have drawn with bio-renders, can I put them in the paper or which other software I can use to draw them?

27 February 2021 8,179 1 View

Can anyone please help me in processing SAR SLC data to generate interferogram using SNAP?

I have two scenes of the study area, one top and the other bottom. As per the tutorials and papers published, the step include coregistering the master sand slave images. However, when i try to...

24 February 2021 6,372 1 View

How do I change a preprint to published?

I want to know how to change the status of an article.

21 February 2021 1,536 2 View

How I can add publication with maiden name?

Good morning, can You please tell me how I can add an article that was published under my maiden name? When I try to add an article with this name, it appears information that I should be an...

21 February 2021 6,866 3 View