What is the difference between EPMA and SEM analysis?

More Mahta Ghadimi's questions See All

Hello!. Has someone an Excel spreadsheet operating under windows of the Fe-Ti oxides?

Hello

29 December 2023 9,686 0 View

Why some Harker diagrams in my stydy area is different than the entire area?

Hello The values of Sr,Nb,Ba and FeOt( Harker diagram) of the samples of my studied area are lower than the samples of the entire area. What could be the reason for that, so I will check one...

11 November 2023 1,273 0 View

Suggest some phd research topic on ML,DL based?

suggest some phd research topic on ML,DL based

22 March 2023 9,141 4 View

What do two half lives mean when they are both reported for a single dtug?

In the article titled "FDOPA-(18F): a PET radiopharmaceutical recently registered for diagnostic use in countries of the European Union", two half-lives are reported for FDOPA....

19 November 2022 7,799 9 View

How Can I Calculate the volume fraction of the retained austenite with XRD results?

There are two similar formulas mentioned in articles to calculate the volume fraction of the retained austenite in Q&P heat treatment. Which formula is more reliable?

15 May 2021 4,231 2 View

How to inter pain intensity data using NRS when patients report their pain in spectrum?

I have been working on a pain intensity study and I wanted my patients to report their pain intensity using numerical rating scale. many patients have reported thier pain in spectrum like 2 to 3...

13 February 2021 6,809 3 View

Can I exclude some of the patients from my study after counting them as my calculated sample size?

In my current research the sample size was calculated to be 500 people. I have gathered the data now I want to cosider my exclusion criteria and exclude 80 of them. therefore only 420 samples...

07 January 2021 3,200 1 View

How to define a wave port in HFSS transient analysis?

I am doing a transient analysis on a horn antenna using HFSS transient. I know that I need to define a so-called ground plane to which the wave port is attached and that is how I would be able to...

27 July 2020 827 3 View

Why do the silica nanocapsules release the highest value of MBT at neutral pH?

2-mercaptobenzothiazole loaded silica has been stirred in 3.5 wt. % NaCl in H2O solution. The release of MBT was evaluated by UV-Vis in different pHs (3 - 11). However, the highest release of MBT...

28 May 2019 1,594 5 View

In the kyphosis surgery when the surgeon uses the bone cement, does he use rods and pins to fix the bone?

when Spinal deviation Increases, it needs to surgery. I want to know more about the ways of this surgery.

21 October 2018 7,584 6 View

How can I prepare virus for a TEM or SEM imaging?

I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?

11 August 2024 3,115 1 View

How to learn more about SPSS and its Application?

I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.

11 August 2024 9,101 4 View

Can I base on reverse DNA sequences to perform alignment, convert to amino acids and GenBank submission?

I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?

11 August 2024 5,138 1 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

Text-Communication from the M1 Hand Area using BCI—and then there is Elon Musk?

Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...

10 August 2024 7,180 0 View

Handling Missing Data and Building a Predictive Model with Incomplete Information ?

I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...

10 August 2024 4,005 2 View

Has anyone applied Python in the field of textile engineering for data analysis, automation, or smart textiles?

I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...

10 August 2024 7,429 2 View

Is it possible to use the Fused Deposition Modeling (FDM) to additively manufacture interconnected porous structure generation of >100-200 micrometer?

Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...

09 August 2024 7,892 0 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

How to define an anisotropic material with asymmetric elastic compliance/stiffness matrix in ANSYS APDL?

I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...

09 August 2024 5,048 2 View