What is the best way of modelling heat transfer in rotating elliptic pipes?

02 February 2014 0 3K Report

I am working on laminar heat transfer in straight elliptic pipe rotating about a parallel axis that is at a distance from the center of rotation of the pipe. What is the best way of modelling this using FLUENT? See the attached document.

Badges
Science topic

More Tajudeen Popoola's questions See All

How to evaluate Tb which is the bulk temperature in FLUENT please?

Nu=hD/k, I want to determine the Nusselt number under constant heat flux condition. Can anyone help to explain how to evaluate Tb which is the bulk temperature in FLUENT please? heat trasfer...

31 December 2015 546 13 View

What is the distance from pipe central axis to the center of rotation in FLUENT?

I am working on heat transfer in rotating pipes that is made to rotate at a distance from the central axis of the pipe in parallel mode. I am using FLUENT for the simulation. Can anyone help to...

01 February 2015 7,717 3 View

How can you determine the local and average Nusselt number in rotating ducts using FLUENT?

I'm working on elliptic geometry that is made to rotate at a distance from the central axis of the duct. I need to determine the local and average Nusselt number. The values being generated from...

06 July 2012 9,993 6 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Can we distinguish the type of free fluid inside the pelvic and abdominal cavities whether blood or serous fluid using the ultrasound?

during ultrasound examination of acute abdomen, sometimes we see free fluid , can we know the type of fluid ,whether blood or not , using ultrasound only? if yes , what are the sonographic...

01 March 2021 7,476 4 View