What is the best wavelentgh for HPLC determination of Fluconazole?

08 July 2020 0 363 Report

Based on the UV-VIS spectrophotometry analysis of fluconazole, the maximum wavelengths were acquired at 210 and 260 nm, and the best results were achieved at 260 nm by UV-VIS spectrophotometry. but in my HPLC analysis, the best data and highest signal were obtained at 210 nm. with regard to conflict information, what is the best wavelength for fluconazole in HPLC analysis?

Badges
Science topic

Similar topics
Agriculture
Horticulture
Seeds

More Forough Karami's questions See All

If Purospher STAR RP-18 LiChroCART (HPLC column) is suitable for amino acids?

Hi Dear Researchers, Could anyone please provide me with some information about the HPLC column, specifically the “Purospher STAR RP-18 LiChroCART Cartridge”? I would like to know if it is...

25 June 2024 9,523 1 View

I'm working on defoamers in gas sweetening process(amine unit). what do you suggest?

I appreciate if you could provide me with good articles or an innovative material which suits my research.

12 September 2023 1,725 0 View

Do I have any chance to purify some DMSO that mixed with water ?

(I'm not sure about how much water was added)

15 July 2023 9,457 6 View

What can i use instead of POCl3 in organic synthesis which somehow could change alcohol to ether?

description is in the file attached.

10 July 2023 2,238 5 View

Artificial intelligence (AI) can help us to mitigate and adapt to climate change. What do you think?

Nowadays, the progress of artificial intelligence (AI) in the world is remarkable. I would like to know if it is possible to get rid of the emergency crisis of climate change through artificial...

02 June 2023 6,862 2 View

Why my protocol for P19 cell differentiation to cardiomyocytes isn't working?

I am culturing 1 million cells in 100 mm non adherent bacterial petridishes in DMEM/F12 supplemented with 1% penstrep and 10% FBS for 4 days to form embryoid bodies and then culture them as mono...

18 December 2022 5,176 4 View

What is normal ktv hemodialysis and peritoneal dialysis ?

how to calculate ktv?

05 December 2022 3,097 3 View

What is the reason of negative response in 3D plots of Central Composite Design?

I used Central Composite Design to optimize effective factors for a typical determination. Now, as shown in attached Figure, in 3D response surface plots, response (peak area) is started from...

01 April 2022 8,672 0 View

Blood brain barrier permeability using FITC-Dextrans?

I am working on emulating a blood brain barrier on a chip and to evaluate paracellular permeability we are using FITC-Dextrans. I am wondering if the permeability of intact blood brain barrier and...

07 February 2022 7,869 1 View

What is the equation for calculating shear stress from volumetric flow rate and geometrical parameters in a rectangular channel?

I want to calculate the shear stress in a rectangular straight/curved channel (the geometry of the rectangle will be fixed), What is the equation that I can use? and also if I want to simulate the...

06 October 2021 1,397 2 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

How to learn more about SPSS and its Application?

I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.

11 August 2024 9,101 4 View

Can I base on reverse DNA sequences to perform alignment, convert to amino acids and GenBank submission?

I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?

11 August 2024 5,138 1 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

Text-Communication from the M1 Hand Area using BCI—and then there is Elon Musk?

Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...

10 August 2024 7,180 0 View

Has anyone applied Python in the field of textile engineering for data analysis, automation, or smart textiles?

I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...

10 August 2024 7,429 2 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

GC-MS retention index prediticon?

Hello experts, Does anyone know any free software about retention index prediction ?

08 August 2024 7,403 2 View

How are iso-frequency contours plotted?

Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...

07 August 2024 1,937 1 View