What is the advantages of zeolite Y as adsorbent over other zeolites?

18 August 2018 1 7K Report

what is the advantages of zeolite Y as adsorbent over other zeolites

The use of zeolite Y as adsorbent is due to its cavity, high surface area, its low Si/Al ratio that implies a high number of adsorption sites, specific property of an adsorbent.

Badges
Science topic

More John Busayo Adeoye's questions See All

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

What is the minimum number of studies in each category required for a multiple subgroup analysis to be viable in a meta-analysis?

Cochrane Handbook mentions subgroup analyses are only warranted if there are more than 10 studies (I have 28), and if they are distributed evenly among categories of subgroup. I am wondering if...

17 February 2021 3,467 4 View

How do you interpret multiple meta-regression in STATA?

Please could someone recommend a resource that explains performing meta-regression with multiple moderators. I have read the STATA META ANALYSIS REFERENCE MANUAL, but this only gives examples of...

17 February 2021 7,376 1 View

How many indicators do I need to represent a latent construct?

Hi folks! We did a large survey and planned to use 3 indicators to represent a latent construct (Sense of Place/SoP) in a latent regression model (structural equation modeling). However, one of...

15 February 2021 7,705 3 View

What is the structure of a photon that can describe the interference experiments that reject the wave nature of light?

De Broglie's double-solution postulated a causal model of Quantum Mechanics. Knowledge of the photon structure was needed to model the particle part of the cause of the Double Slit interference...

11 February 2021 6,869 5 View

How do you incorporate a study that used non-parametric analysis into a meta-analysis where majority of studies used parametric?

I am calculating Hedge's g for effect sizes, so I am pulling means, SDs, and Ns, from each study. However, one study did a Mann-Whitney U test, and so reports Mean Rank, Sum of Ranks, U, Z, and r...

31 January 2021 1,182 5 View

How to share a struct between client.c and server.c in Contiki RPL UDP ?

I'm trying to include udp-client.c in udp-server.c to share a struct between them But I keep getting this error udp-server.c:67:1: error: redefinition of autostart_processes In file included...

16 January 2021 5,013 4 View

Do you know any CEFR-annotated learner corpora for writing tasks?

Dear researchers, I have been working on a machine learning algorithm to classify language learners' writing tasks automatically according to the CEFR levels. The aim is to use...

03 January 2021 7,041 2 View

Who are the leading Indigenous academics who have researched and published on STEM teaching and learning?

I'm interested to read what leading Indigenous academics have to say about the intersection between traditional or Indigenous knowledges/epistemologies, values/axiologies and ways of...

14 December 2020 10,026 10 View

How to performe a non-inferiority test in an adjusted linear regression?

I am looking for the relation between weight evolution (continuous) and a binary factor adjusted for confounders. The regression gives an (adjusted) difference and its CI less than the planned a...

13 December 2020 8,061 3 View

In methylene blue test Why is UV absorbance reading very low as soon adsorbent is added and then increasing before reaching equilibrium?

Hello, I'm working on removal of methylene blue. 01. in the dark test very first reading is taken 15 minutes after adding adsorbent to the dye solution and that UV absorbance reading is very...

19 February 2021 472 5 View

What is the mechanism or interaction between Fe3O4 magnetic nanoparticles and biochar?

Lately there are many studies on biochar incorporated/loaded/coated with Fe3O4 magnetic nanoparticles. But I havent found any paper that describes the interaction or bonding between the two. How...

20 January 2021 3,162 4 View

Which peak should I consider when calculating ZIF-8's crystalline size from XRD?

Hello, Using the Scherrer's equation, one could calculate, roughly, the crystalline size of ZIF-8. However, I am confused as to which peak in the XRD pattern should be taken for the calculation?...

10 January 2021 8,633 3 View

Does low pHPZC (Zero point charge) indicates higher negative charged surface ?

I found that, there is a difference in pHPZC value when higher impregnation ratio of acid on adsorbent surface. Lower pHPZC value when higher ratio of acid impregnation and adsorption performance...

05 January 2021 7,224 3 View

How I can choose best response surface methodology design for optimisation of of PH, temperature, metal ion concentration, adsorbent dose?

I wanted to use CCD aur box-behnken design Which one is better and how I can do experiment using design expert software

13 December 2020 6,323 5 View

Approval for MnFe2O4 for industrial wastewater treatment?

I am using MnFe2O4 NPs as adsorbent for CrVI for wastewater treatment following literatures as it is one of the best, but I have a challenge of releasing Mn+2 in the environment. A lot of...

19 November 2020 3,404 4 View

How do I keep the pH in a batch test constant using a shaker?

I am conducting a batch test with a locally produced adsorbent with a major constituent of Calcium oxide and adsorbate (carbarmazepine, sulfamethoxazole and diclofenac). I want to keep the pH...

18 November 2020 703 6 View

How adsorbed Mercury (II) react with HCl and HNO3 in water?

Case: Hg2+ is adsorbed on a titanium carbide and 0.1 M HCl/HNO3 is used for the desorption of Hg2+. During the reaction, the solution turns into a pale yellow color. I want to understand what...

16 November 2020 5,770 3 View

Effect of adsorbent porosity on efficiency of adsorbent recovery ?

Hi guys. Can anyone answer the following with citing the references? 1) Relationship between adsorbent porosity and adsorption/desorption rate? 2)Relationship between porosity and adsorbent...

31 October 2020 6,323 5 View

Effect of initial dye concentration ( methylene blue) on removal percentage?

i am studying the variables (study of initial dye concentration ) for removing methylene blue (mb) using a composite that i prepared. the results showed that on increasing dye conc, the removal...

01 October 2020 3,016 3 View