Sir,I have 38MnVS6 microalloyed steel,what should be its deformation temperature?

and which thermo mechanical treatment is suitable as deformation treatment(rolling or forging)? Is it possible to take deformation temperature is below 1000 degree celcius for this particular...

10 November 2015 5,315 2 View

How to decide the deformation temperature for thermomechanical treatment of microalloyed steel?

on what parameters this is depends? for rolling/forging how to decide their temperature?

10 November 2015 10,003 2 View

Is there any effect of the spraying process on nanostructured YSZ thermal barrier coating?

spraying processes such as APS ,HVOF Which one is the best for TBC and why ?

03 April 2015 8,029 1 View

What is the effect of grain growth on nano structured zirconia thermal barrier coating ?

exactly what happens if grain growth occurs at high temperature. What is the effect on its applications?

03 April 2015 353 3 View

The property of material can't be significantly change by heat treatment?

1 Yield strength 2 UTS 3 Ductility 4 Elastic modulus

08 September 2014 8,894 2 View

Looking for Materials with high thermal expansion coefficient and high temperature resistance?

03 March 2021 8,272 1 View

What are anisotropic electrical and optical properties of a semiconductor due to?

In some materials, properties such as band gap, thermal conductivity differ along different crystallographic axes. What are the basics?

01 March 2021 1,923 3 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

Why do a weight decrease for thermal degradation in nitrogen gas condition?

Hi all The question is related to TGA(Thermogravimetric analysis). Thermal degradation easily understood but why do samples weight decrease? altough just binding is broked, the weight of...

26 February 2021 1,100 5 View

Can thermal cycler machines be problematic during PCR?

Hi, my question is about the heating of thermal cycler machines and I hope some of you had experienced a similar thing previously. There are two thermal cycler machines in the lab(BioRad) and for...

26 February 2021 4,777 4 View

How to increase solubility of Poly acrylic acid in Dioxane solvent?

I am working with Polyacrylic acid (100.000Da) and instead of water, I need to use another solvent (dioxane) to dissolve PAA. However, because of the high molecular weight, it's quite hard to...

25 February 2021 2,225 5 View

Can MicroRNA cross the blood brain barrier?

In diseased conditions, many genes and gene products are visible in the bloodstream. So my question is whether we can find traces of microRNA which is involved in disease and disorder in blood serum?

24 February 2021 7,064 3 View

How can I verify my centrifugal fan design for electric motor cooling?

I have radial blade centrifugal fan design which will be mounted on exhaust side of electric traction motor. The fan will be mounted on same motor shaft inside the housing. How can I verify that...

23 February 2021 2,390 3 View

Thermal reduction of graphene oxide.?

I am trying to reduce graphene oxide by thermally but I have no proper information regarding this. Can any one help me regarding the details about temperature and time for the reduction of...

23 February 2021 4,155 4 View

What is the system of units used in the thermal conductivity by Spitzer and Harm?

23 February 2021 9,253 1 View