What happens if homogenizer passes are increased more than needed?

18 March 2017 0 1K Report

What happens to the cells/yield, if high pressure homogenizer passes (For microbial cell lysis and release of intracellular product) are increased more than needed?

Badges
Science topic

More Vishnu Kanth's questions See All

Why got population shift in flow cytometer?

Hello connection While performing potency test by using BD FACS instrument some time we few population inside the gate few outside of gate and some time I got population outside of the gate I am...

17 March 2024 3,511 4 View

Suggest me one topic in psychology at effect of childhood trauma on mental health?

effect of childhood trauma on mental health

12 September 2023 5,093 2 View

Whether the XRD and FT-IR of the material before and after the photocatalytic reaction can be compared to know the change in structure of the mat. ?

Kindly provide the details

30 August 2023 4,884 1 View

How to calculate standard free energy change for the following reaction using Born-Haber cycle using DFT?

I am referring Theoretical studies on electrochemistry of p-aminophenol paper for calculating the theoretical redox potential using the described in this paper. I reproduce the DFT calculations...

18 August 2023 3,573 1 View

How to calculate the free energy change of solvation for system A + 2H(+) + 2 e(-) --> AH2 to calculate the theoretical redox potential?

I encountered the calculations in the research article titled "Theoretical studies on electrochemistry of p-aminophenol ." However, I'm having difficulty comprehending the procedure used to...

13 August 2023 1,639 1 View

Inquiry regarding the thermal kinetics observed in a Differential Scanning Calorimetry (DSC) analysis?

I have a query is that after crystallization peak point some of other noise type peaks occur in DSC scan for (Se78-xTe20Sn2Znx) x=2 and x=6 ,this peak shown the material property or due to...

05 August 2023 8,945 1 View

Gaussian 16, maximum force is not converged, all other parameters converged. How to solve this issue?

I am trying to optimize the geometry of a reactant complex obtained from the IRC. The geometry of the product complex is getting optimized, but in the reactant complex, the maximum force is not...

23 May 2023 8,098 3 View

Why I am not able to isolate the plasmid after get colony PCR postive?

Hello everyone, In my case, i ligated my insert (804 bp) into pET30a expression vector (5422bp) 3:1 ratio containing 20 ul reaction by using T4 DNA ligase and incubated at 24 degree centigrade...

16 May 2023 884 3 View

Why my cloning are not working ?

Hello everyone, I have one doubt regarding cloning ? I am using pET30a (+) vector for cloning (5422bp) and Insert size 804bp. I tried all the ligation reaction ratio lilke 1:3, 1:5, 1;7 (100ng...

26 March 2023 7,023 6 View

What are the advantages of using C-rate, rather than A/g, to measure battery performance?

Some journal reviewers prefer that the rate performance of batteries be expressed in C rate rather than A/g. However, since battery capacities vary across different chemistries, wouldn't A/g be a...

20 February 2023 973 1 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

Could it be a cell culture contamination?

Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...

09 August 2024 2,824 3 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

Why do i have a weak plasma and no coating during rf sputtering?

I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.

07 August 2024 4,526 4 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

How to assess the osmotic power of a substance?

Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...

06 August 2024 977 1 View

RNA later for the preservation of RNA in fecal samples at room temperature for one day (37°C)?

I am planning to collect human fecal samples for metatranscriptomic analysis using MGI. These samples are from indigenous people living in a region with high temperatures. I will have access to a...

06 August 2024 1,367 3 View