What amount of quantity of cellulase enzyme should take to perform enzymatic hydrolysis of cellulose ?

05 August 2023 0 4K Report

how to calculate FPU in grams ?

In every journals, it was mentioned that they have taken 20, 30,50 FPU of cellulase enzyme to perform the enzymatic hydrolysis but they did not mention it in grams.

Badges
Science topic

Similar topics
Correction

More Deepak Jyoti Deuri's questions See All

Why Cl atom is not showing in docked comlex of molecule?

During the preparation of a ligand molecule in autodock or openbabel Cl atom is not showing in the .pdbqt file whereas it was present in the pdb and sdf file. Due to this Cl atom is not showing in...

13 July 2024 3,486 6 View

How can I verify if an academic journal is a legitimate publication or a cloned version?

This question seeks to address the growing concern of cloned academic journals, which are fraudulent duplicates of legitimate publications. It aims to guide researchers, scholars, and academics on...

10 July 2024 5,966 2 View

Can you suggest any software to draw shadow mask pattern for lithography?

I need some mask for UV photolithography. Can you suggest any software to draw those patterns with proper file format so that directly the file can be inserted and required pattern can be...

22 May 2024 9,449 3 View

Anyone have crack version of casaXPS for macbook?

I need a cracked version of origin pro and casaXPS for MacBook AIR M1

12 May 2024 7,259 0 View

How is to find the correct bandgap from a Tauc plot having 2 humps extracted from a UV absorption data ?

In order to find the band gap, I plotted a tauc plot of a UV absorption data. The Tauc plot contains two slopes as shown in the figure. Kindly tell me how to obtain the correct optical band gap...

12 May 2024 5,449 3 View

Can we use panel ARDL model with dummy if we have T=20 and N=8, given the condition that DV is I(0) and IV are mix of I(1) and I(0)?

Can we use panel ARDL model with dummy if we have T=20 and N=8, given the condition that DV is I(0) and IV are mix of I(1) and I(0)...

07 May 2024 943 0 View

Require single protocol for mice brain (hippocampus) homogenization for ELISA, GSH, and NO assay?

I plan to do ELISA, GSH, and NO assay from mice hippocampus. However, because of limited tissue, I can't homogenise tissue according to different protocols. By doing some literature, below is the...

15 April 2024 8,423 0 View

Can the concentration of sodium be higher than chloride in groundwater?

I have analyzed groundwater of the middle indo-gangetic plain and detected the Na ion concentration (90 mg/L) and Cl ion (1.7 mg/L). Is it possible?

12 April 2024 3,452 6 View

How to Solve Inaccurate quadrature in CalDSu. errors in Gaussian?

in optimization process its showing for carbohydrates computational studies. How to Solve Inaccurate quadrature in CalDSu. errors in Gaussian?

05 April 2024 1,389 1 View

Does the DNS method for the analysis of reducing sugars shows the UV-Abs shift at 370 ?

We followed the NREL laboratory protocol to analyze reducing sugar after pretreatment of biomass via DNS method. But everytime we found the UV-Abs peak at 370 instead of 540nm. Suggestions are...

15 February 2024 2,605 0 View

How do I convert cellulase enzyme 10,000U/g to mg/g fresh forage or mg/kg fresh forage?

I would like to know the minimum amount of Cellulase enzyme that could be used for silage making.

03 August 2024 3,170 1 View

Is it possible to use a safer acid instead of monochloroacetic acid to convert bacterial cellulose to carboxymethyl cellulose?

Hi, researchers, Is it possible to use a safer acid instead of monochloroacetic acid to convert bacterial cellulose to carboxymethyl cellulose?

29 July 2024 4,570 0 View

What is the exact procedure and materials for converting from ester to carbolic acid by base hydrolysis??

11 July 2024 4,645 3 View

Is the use of microcrystalline cellulose MCC 102 in direct compression technology justified, given the low flowability of this excipient?

Hello everyone reading this topic! It is well known that microcrystalline cellulose 102 is recommended for use in direct compression technology, however, like other grades, it has poor flowability...

08 July 2024 2,807 0 View

How is the deconvolution area method applied to determine the crystallinity of cellulose using X-ray diffraction (XRD)? ?

I use X-ray diffraction (XRD) techniques to quantify the degree of crystallinity in my samples, referring to the following formula (CrI=Acrystal-Aamph/Atotal ). using deconvolution area methods (...

06 July 2024 6,234 9 View

Cellulose degradation rate in anaerobic digestion?

Hello, I am looking for (estimated) degradation rates of cellulose in a classic anaerobic digestion setup (meso or thermophilic, WWTP sludge, 30+ days of operation) to have an idea of the % of...

01 July 2024 5,867 5 View

Is water a good solvent for Non contact mode of Atomic Force Microscopy analysis of bacteria degraded lignin and carboxy methyl cellulose?

I am studying the surface topography of bacteria-degraded cellulose and lignin using the non-contact mode of Atomic Force Microscopy (AFM), which requires a solvent to make a dispersion of the...

21 May 2024 6,358 3 View

How can I determine the best condition for an endonuclease reaction?

Probably this question seems fool to you, but I am quite new in the research area and there are a lot of experiments I have never done. My question regards the amount of buffer, enzyme, incubation...

15 May 2024 3,993 1 View

Can you suggest lab services in India for determination of cellulose hemicellulose and lignin content in plant biomass?

I want to know affordable lab services in India for the said analysis

13 May 2024 4,186 1 View

How to increase molecular weight or further polymerize cellulose triacetate?

Hi all! I would like to know if there is a method to polymerize low MW cellulose triacetate (e.g. re-engaging in acetylation). Or this is not possible and the MW of my cellulose source should be...

08 May 2024 5,260 1 View