Hi,
I am working on USRP N210 and Matlab 2016R.
I want a transfer a Sinusoidal wave from one port of Antenna
and want to receive same wave from second Antenna at one USRP N210 (unfortinaly I dont have two USRP N210).
How I will do…
Do you have some exaples ?
Actually I have done this job but problem is this that after removing
both Antenna from USRP N210 I am still getting same wave.But that must not be happened.
With regards,
Ivana
I would ask you an explanation question. Could you tell us how can you input a sine wave from an antenna port and you you get it at the output of the second antenna port.
This means that one works as a receiver and the other must work as a transmitter. What is the value of the frequency of the received sine wave.
It must be in range of the carrier frequency of the kit say fc.
You have to receive it after the LNA and insert it to the input of the power amplifier of the second kit which will amplify it and output it to the other antenna port.
This means that you use only a small part of the kit.
Best wishes
I would like to suggest you to follow Ruby forum for your query such as https://www.ruby-forum.com/t/transmit-from-rf1-receive-from-rf2/239697
Also: http://ecewp.ece.wpi.edu/wordpress/wireless/files/2011/11/ece4305_lab0.pdf
I would ask you an explanation question. Could you tell us how can you input a sine wave from an antenna port and you you get it at the output of the second antenna port.
This means that one works as a receiver and the other must work as a transmitter. What is the value of the frequency of the received sine wave.
It must be in range of the carrier frequency of the kit say fc.
You have to receive it after the LNA and insert it to the input of the power amplifier of the second kit which will amplify it and output it to the other antenna port.
This means that you use only a small part of the kit.
Best wishes
- Badges
- Science topic