I am trying to boil water that enters the tube through inlet, and exits as super heated steam at outlet. Constant heat flux is being used. I am new to CFD. Could you please suggest how to go about it. I am currently using VOF model and the flow is laminar. I think the issue is with boundary conditions. Could someone give a short summary on this?
Muhammad Ahson Anwaar
Well, I have inlet mass flow of 0.0000277 kg/s, at 300K and 350Kpa.
At outlet, i have a pressure outlet, super heated steam is desired at 573K and 350Kpa. Mass flowrate is constant through out. A wall heat flux was applied. I hope this helps.
0 votes
0 thanks
Luigi Candido
Hi Muhammad Ahson Anwaar
If you use COMSOL, you can take a look to this:
https://www.youtube.com/watch?v=Awwza_v27EA
Regards,
LC
0 votes
0 thanks
- Badges
- Science topic
More Muhammad Ahson Anwaar's questions See All
Similar questions and discussions