25 August 2022 0 4K Report

I am trying to CRISPR a number of gastric cell lines but can't find any published parameters for these particular cells and am hoping to avoid doing a full optimisation.

More Cushla Mckinney's questions See All
How can I calculate the synergistic effect of three engineering activities operating in parallel. Is there a formula?

Systems Engineering (SE), Digital Engineering (DE) and Mission Engineering (ME) are three distinct approaches to designing and developing complicated systems. We are just now seeing the three...

26 November 2022 6,721 2 View

Why are the SV40PolyA signal and downstream sequence elements inverted in many common expression plasmids?

Rather than have the SV40 PolyA sequence and 3' elements 5' to 3' on the coding strand, many reporeter expression vectors (such as EGFP) have the PolyA 5' to 3' on the opposite strand (with the...

20 July 2021 1,542 2 View

Any advice on efficient transfection of THP-1 cells?

Good morning, I am trying to introduce an expression plasmid into THP-1 cells and have come across a couple of papers that describe electroporation techniques but on different machine than we have...

18 November 2015 1,286 3 View

Similar questions and discussions
Why Do TDS and EC Increase with Larger Wastewater Volumes, While BOD and COD Decrease?

I have carried out MFC experiments on three different volumes, 50, 500 and 1000 mL of wastewater. Results after MFC treatment shows that TDS and EC are more in larger volumes of water i.e. TDS and...

09 August 2024 9,621 0 View

Could it be a cell culture contamination?

Hello everyone! I observed in my culture (htert-RPE1 cells) an orange- red particle at the bottom of the dish. It is visible to the naked eye as a very very small red dot. Could it be a...

09 August 2024 2,822 3 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

Is there anyone with experience in TEM analysis who can assist with a manuscript for an upcoming journal?

Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...

07 August 2024 9,561 0 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,105 4 View

Hello Everyone ! I'm looking for a good journal to publish my manuscript with low publication cost?

I am Looking for a Science Journal with good impact factor and low publication cost to publish a review paper. Your suggestions would be appreciated.

06 August 2024 6,795 3 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 639 2 View

Is an invitation to join the editorial board of Clinical Cardiology Updates a scam?

I received an e-mail invitation to join the editorial board of Clinical Cardiology Updates. While I have published a few articles related to cardiovascular disease, there are lots of colleagues...

06 August 2024 8,981 8 View

Why is the Protocol for Preventing Postpartum Hemorrhage (https://pubmed.ncbi.nlm.nih.gov/36113283/ ) not being widely adopted?

If the placenta is delivered in squatting position within 3 minutes of the birth of the baby, postpartum hemorrhage is completely eliminated. It works every time. It is quite likely that if a...

05 August 2024 8,895 0 View

How to Add Missing Water Molecules in Protein-Membrane Simulations?

I have protein-membrane simulations (PDB, PSF, DCD) and have noticed that water molecules near the protein are not visible in the simulations. How can I fix this issue? Is there a way to place the...

04 August 2024 1,200 2 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close