i'' modeling a RC frame in abaqus , so i need the data of ISO 834-1.
Is there anyone to share this code ?
some data must be extracted from this code such as conductivity ,...
Dear Sa Sa,
in this context, you might find useful the information given in a manuscript titled "Numerical Study on Steel Fiber Reinforced Concrete Columns Subjected to Fire" on Page # 153 available in the proceedings of the SiF'2016 accessible at:
http://www.structuresinfire.com/corpo/conferences/sif16.pdf
Good luck,
Vasant Matsagar.
https://www.youtube.com/watch?v=rV21yiXLVfw
Hello , I have modeled a RC frame in Abaqus. As well as that , i have defined CDP properties of concrete into my model based on Mander relations ( Confined Concrete ) and have modeled the...
31 December 2017 7,628 3 View
Hello I have modeled a RC(Reinforcement Concrete) Frame concrete in Abaqus , so i have some questions about modeling below : 1- How to define a concrete fixed joint between beam and column? 2-How...
31 December 2017 9,410 2 View
I'm modeling a thermal finite element model of RC frame ,so i have faced some problems although i could not solve them by any searching of a variety of articles I'm looking for below cases : 1- A...
11 December 2017 3,821 4 View
I have input a moment load in module load Abaqus, i put my moment load on the node surface (using reference point). I have define moment in history output and make a set for moment too. But the...
08 August 2024 4,831 4 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...
05 August 2024 454 3 View
Hello, colleagues. Recently, I have been working on a metal processing simulation with my UMAT in Abaqus. I have outlined the corresponding simulation, but I keep encountering issues that cause...
30 July 2024 7,062 1 View
I am trying to run a restart analysis, which imports deformed configurations of parts from a generated ODB file. It runs fine in Windows OS but when I try to run it in Linux OS, it is giving some...
29 July 2024 9,572 3 View
Sure, here is the translation: I have a 3D orthogonal woven composite structure where warp, weft, and binder yarns are oriented in three directions. After modeling these yarns and the matrix in...
28 July 2024 8,169 0 View
hi, I am doing a risk analysis of a cylindrical fuselage with windows. I have applied contact interactions between the different parts, and I have applied a unit value load to a reference point,...
20 July 2024 647 2 View
In 2018 the OHSAS 18001 was improved and progressed into ISO 45001. This was characterized by one or two short falls. I am now reviewing the ISO 45001, with the aim of looking at the entire...
18 July 2024 9,489 0 View
Hi all, I am using the element deletion process based on a Tsai-Wu criterion through a UMAT with a specific State Value controlling the process (DepVar -> Variable number controlling element...
17 July 2024 1,501 1 View
I saw a paper(PHAN V-T, ZHANG X, LI Y, et al. Microscale modeling of creep deformation and rupture in Nickel-based superalloy IN 617 at high temperature [J]. Mechanics of Materials, 2017, 114:...
16 July 2024 8,436 0 View