in TG test , why sometime it's found increase in mass % with increase in temperature ? for glass ceramic .
It depends on the type of the tested glass and the atmosphere of the experiment too. If it's TG in air atmosphere, you can assume it's consuming oxygen present in the air, therefore the mass is being increased.
Possible generic reasons for weight gain detection in TGA were discussed elsewere at this forum:
https://www.researchgate.net/post/Why_my_TGA_graph_shows_a_weight_gain https://www.researchgate.net/post/What_is_the_process_to_get_a_weight_Gain_in_TGA https://www.researchgate.net/post/What_are_the_reasons_for_weight_gain_in_TG_curve_My_sample_is_Cement_and_the_weight_gain_is_in_the_temp_range_of_400_to_650_degree
En suivant toutes les étapes mentionnées sur (ajouter une recherche) il me signale erreur, ressayer, j'ai essayé plusieurs fois, sans succès, toujours il me signal erreur, ressayer
02 August 2024 9,719 1 View
As one can read in numerous papers on this matter, the dislocation density is derived from the dependence of peak broadening on the diffraction angle, that is, on considered reflections. Thus, to...
28 July 2024 6,496 5 View
with secondary data collected from central bank to know the impact of digitalization in banks profitability, how can its impact be more precisely measured through econometric tools.
21 July 2024 7,295 10 View
I try to understand the ESP mechanism working. What kind of sensors it has, Is it necessary to modify or boost its mechanical ?
15 July 2024 4,772 1 View
Mangroves were reported to eat into limestone atolls like so much cake - but could it have been diatom partnerships at mangrove roots that ate into the rock? If gypsum formation is a clue, how...
12 July 2024 159 2 View
This question seeks to address the growing concern of cloned academic journals, which are fraudulent duplicates of legitimate publications. It aims to guide researchers, scholars, and academics on...
10 July 2024 5,966 2 View
Hi, Just curious to know that in chromatography, a chromatogram should be zoomed to what scale? 10 times of output , 50X or ..? Is there any regulation or general chapter which describes this?...
03 July 2024 3,119 6 View
I am working on one protein which gets aggregated (similar to alpha-synuclein and tau) in certain neurodegenerative diseases. I am trying to confirm the aggregation using Western blotting....
30 June 2024 5,060 3 View
Dear colleagues, I would be grateful to anyone who can answer my two questions: 1. Do the proportions of the shark's body change after drying? In other words, is it possible to discriminate two...
30 June 2024 6,101 3 View
Please, can any one inform us about risks of graphene and graphene oxide as a factor of cancer growth?
28 June 2024 6,815 4 View
I need a very narrow glass capillary for my research. How can I make a glass capillary with an inner diameter of around 200 to 500 nanometers?
08 August 2024 8,915 0 View
I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...
07 August 2024 5,177 3 View
Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM or SEM images?
25 July 2024 5,482 2 View
I will polymerise Aniline on ITO glass WE, using 1M of H2SO4 and a potentiostat. However, I am not sure if I have to do the electrochemical polymerisation inside a hood. Is it necessary? Is the...
10 July 2024 2,937 3 View
..
10 July 2024 3,444 4 View
as of my knowledge z90 is acrylic based sealant adhesive.
09 July 2024 8,660 4 View
Dear Prof, is there a subtle distinction between the terms "substitution" and "doping" when referring to modifying ceramic dielectric materials for example Na0.5Bi0.5TiO3? Is there any difference...
08 July 2024 2,043 3 View
Hi all, I am looking glass cilinders that have an open flat bottom and top. Preferably with the inner diameter in the range of 2 cm. It's similar to the ones found on multi-electrode arrays for...
06 July 2024 5,846 1 View
If we want to introduce a material similar to polymethyl methacrylate "with the characteristics mentioned in the next paragraph" that can be added to a precursor and create a composite, which...
03 July 2024 2,371 1 View
I use PDMS to build a microfluidic system, but it is not hardening at all, although I use TEOS as a cross-linker and also ATPES in a ratio of 1:10, and it's been 3 days at 80 degrees of 3 ml cast...
01 July 2024 604 3 View