Textured piezoelectric ceramics

More Tarun Yadav's questions See All

How optimize the Size Exclusion Chromatography?

Hello! I'll do a size exclusion chromatography, but I only have an open column, and I'll perform the peptide extraction from yeast, using buffer lysis (sodium phosphate 50 mM/NaCl 30 mM/DNAse and...

01 March 2021 2,215 2 View

Why am i not getting solid after reacting APTES with salicylaldehyde?

The reaction of APTES with salicylaldehyde in ethanol leads to the formation of imine compound yellow solid which is mention in literature, but I am not getting yellow solid I don't know why? when...

28 February 2021 2,955 2 View

When is it unnecessary to change organisational culture?

As a former management practitioner, I recall a generally accepted view that changing organisational culture is difficult, so you should only attempt it if the organisational change that you are...

27 February 2021 2,595 8 View

Which indexation is better Scopus or Web of Science?

Both are very repetitive indexing agencies.

26 February 2021 9,455 4 View

Anybody write me the name of scopus journals in commerce, management, economics areas. Which publish without any charge?

Please write those scopus journal names for which you have good experience with them.

24 February 2021 6,210 1 View

How to extract water soluble amino compound from after aqueous work up?

4-Dimethyl amino pyridine is used in reaction.Product formed contains amino group along with amide & is highly water soluble. To remove 4-DMAP aqueous work up done. Please give solution. Thanks.

21 February 2021 1,883 1 View

Which software is best to analyse multi-phase fluid flows ?

Hello everyone, hope all is good. I want to analyse multi-phase fluid flow through pipe, which software is best to do so ?

21 February 2021 4,230 8 View

How to decrease the time for publication of paper in a journal ?

It takes a lot of time in publishing the paper in the journal, from few months to a year so how one can able to decrease the time for publication.

17 February 2021 2,997 14 View

Can anyone suggest a software for running a plant tissue culture lab?

A software which can help to design the experiment, store data, update new data, set subculture reminders, barcoding etc. Like Invitrosoft.

17 February 2021 3,015 5 View

Do you think NCC and 3 year service at army base must be compulsory to make the students loyal and discipline to the nation?

Decipline and loyalty for nation is the need of today.

09 February 2021 6,928 3 View

Is it possible to do piezoelectric coupling in ANSYS-APDL or COMSOL between tapered substrate and rectangular piezoelectric patch?

How to do Piezoelectric coupling in ANSYS-APDL or COMSOL between tapered substrate and rectangular piezoelectric patch? Piezoelectric coupling between the rectangular substrate and rectangular...

02 March 2021 9,833 3 View

How can I measure the thickness of thin layers deposited on textured glass susbtrates?

I want to measure the thickness of aluminum oxide and titanium oxide layers deposited on textured glass substates. The layer thicknesses are typically below 100nm.

21 February 2021 5,465 4 View

What is difference between In-line transmission (%) and Total transmission (%) value of optically transparent Ceramics?

I am working on transparent/translucent zirconia-based ceramics. In many papers, I have seen that they are reporting both In-line transmission (%) & Total transmission (%) value of...

20 February 2021 9,405 6 View

How to do buckling analysis in ansys apdl for laminated plate with PZT 5H attached?

I am doing buckling analysis of laminated plate surface bounded with two piezoelectric PZT 5H and axial compressive load is applied. I am getting an error, No ANEL table exists for material 2....

16 February 2021 510 1 View

Using liquids as superstrate in Fabry-Perot Cavity Antenna?

Hi, A Fabry Perot Cavity allows to increase the directivity of a low gain antenna by putting in the top of cavity a superstrate with high permittivity such as a ceramic (er=10.2). However,...

09 February 2021 6,799 8 View

Sample preparation for ceramics i.e. iron silicate (fayalite), iron oxides, alumina, spinel mineral (hercynite)?

Recommendations in preparing ceramics for nanoindentation and in the process minimize introducing stresses from sample preparation i.e. polishing stage.

02 February 2021 6,211 3 View

What should I do if the reviewer couldn't finalize the review in the journal's given time?

I have Submitted 2,3 Papers in Science Direct associated Journals but the time of the first decision has been ended so What should I do? Could I email them to remind them about the first decision?

01 February 2021 5,788 7 View

What are the thermodynamic and kinetic similarities and differences among dendrite formation during solidification of metals, ceramics and polymers?

Basic dendrite formation of metallic alloys are explained by thermal and constitutional degree of supercooling and most-supercooled band of liquid somewhat ahead of solidification front that...

30 January 2021 8,450 2 View

Why can't I get an Sdr value when measuring surface texture parameters?

I am performing a texture surface analysis of a polished ceramic surface using an optical profiler; amongst the parameters I am measuring is the Sdr. I got values for the Sdr when I analyzed my...

25 January 2021 4,462 3 View

What is the maximum voltage a piezoelectric PZT layer can handle?

I have a circular PZT layer deposited by PLD method. The dimensions are: 20um diameter and 350nm thick. It has 100nm Pt electrodes sputtered on the top and bottom. I would like to know what is the...

25 January 2021 688 5 View