Hello,
do you have any idea about the required time to simulate SAR for voxel human body model?
thank you
Hi Sondos Mehri ,
SAR simulation time primarily depends on the following parameters.
1. dimension of voxel model
2. Frequency of operation
3. Number of mesh cells (lines per wavelength)
You can control the SAR simulation time by varying the following parameters.
Thanks a lot.
Hello everyone, I am an undergraduate student looking to seek peer review for my research. Are there specific platforms or forums where I can connect with knowledgeable reviewers in my field?...
13 June 2024 2,084 2 View
I need clarification on the appropriate timing for administering prophylactic antibiotics to cancer patients.
29 April 2024 7,106 2 View
How can I determine?
08 January 2024 4,275 0 View
We are planning to check the level of phosphorylation of NF-KB in the CD4+ T cell population after activation with anti-CD3/CD28 and treatment for 15 minutes. However, I constantly see two fixed...
29 October 2023 1,561 1 View
Hello, I have received a number of 0.0033781 = CPE 1-T from ZVIEW software, which is very different from the capacitance obtained from cyclic voltammetry (about 1300 F/g). Should this number be...
04 July 2023 2,236 6 View
Taking into consideration that my DNA can be prepared in low quantities (~35ng/micro L), average final volume 50 micro L. I have tried many protocols as almost them require much higher quantities...
29 April 2023 2,513 3 View
I carry out research on the Political Heritage of the Olympic games left for the host. If you have any scientific documents or willing to cooperate, I will appreciate to send me. Thank you
20 December 2022 9,733 1 View
Hi everyone, We wanted to do Intracellular cytokine staining on activated T cells and need to make sure about their gate in the flow-cytometer. We're using isolated human PBMCs and activating them...
09 August 2022 6,634 6 View
Can you introduce me some JCR Journals (free of charge) that aim and scope of them are in the field of fuzzy graph theory?
22 July 2022 7,693 0 View
Ti ions were incorporated as dopants into alumina crystals. Then, alumina peaks shifted a little to the lower angles. On the other hand, there is a sharp decrease in the intensity of alumina...
20 March 2022 3,491 8 View
Approximate concentrations are require in compared with the WHO permissible limts
11 August 2024 2,723 1 View
Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?
06 August 2024 980 5 View
Hi, i would like to simulate an absorption process in Aspen Plus. I want to use the NRTL model und would like to add some individual Henry coefficients. Is that possible and how?
05 August 2024 2,333 2 View
TEP presentation caption (The Environmental Project) Re: Why should Washington’s DC, or any country government point of location think of as nowadays of as to being 'tomorrow as to come! if it...
03 August 2024 2,484 1 View
Why is TLC not a form of partition chromatography and paper chromatography not a form of absorption chromatography?
03 August 2024 7,035 3 View
On a personal note, even though technology has attracted a lot of interest and funding to combat climate change, it is becoming more and more clear that taking care of the "Human Dimension" is...
02 August 2024 6,773 12 View
...
31 July 2024 1,671 3 View
Dear all! Oxygen vacancies do raise negatively the Fermi level by increasing the negative charge in the semiconductor crystal structure. In the case of n-type semiconductors, I wonder if this...
30 July 2024 8,339 2 View
Hello Everyone! I am trying to create a metal hydride system where I am trying to create a temperature control with the emphasis on measuring the concentration of the hydrogen with the hydrogen...
29 July 2024 7,577 2 View
Hello , I established a stable cell line expressing GFP tagged to a centrosomal gene having G418 drug selection marker. I validated the stable line by IFA and Western blotting, results are fine....
29 July 2024 5,007 0 View