I simulated a stirred tank baffled with a Rushton turbine using OpenFOAM. But this simulation doesn't match with problem physics.I can't find a solution to this problem. Can you help me?
Hello, in my opinion, please check the boundary conditions as well as the mesh used, this may cause errors or changes from the actual phenomenon.
I am available for any other suggestions, good luck
Hello, I appreciate your response.
After reviewing this configuration, I ultimately made the decision to alter the plot drafting technique.
In Paraview, I construct a Plot Over Line. Nevertheless, the outcomes did not align with the findings from the experiment.
Although the experiments were conducted for turbulent flow and the velocity is different, the laminar results should match the laboratory results.
nearly It is a validation. Howere result of simulation is about laminar model but result of experiment is about turbulent.
I have problem in RAS model too. results are very diffrent.
Can you help me?
I have to compare the KOmegaSST result to the experimental result. However, does not match the level of KOmegaSST to the experiment. I sent both of them before. please check Ur/Utip in X coordinate. Utip in simulation is 0.974.
So if I calculate Ur/Utip, does not match of KOmegaSST to the experiment too.
- Badges
- Science topic
- Similar topics
- Geoscience
- Atmospheric Sciences
- Climate Science
- Climate Change