Hi all,
is there any proper way, how to determine a signal-to-noise ratio in mass spectrometry, in particular in TGA-MS system?
And do I really need it when I already have my LOD and LOQ calculated against a sufficient amount of blanks?
Thanks,
Jan
Perhaps this article will help.
You don't need signal to noise ratio if you already have LOD and LOQ
Dear Sirs,
Thank you both for your answers.
04 May 2019 1,264 7 View
31 December 2018 3,144 4 View
Hi all, do you know about any commercial service which offers CryoMilling? We have a few samples of plastics (including e.g. PET) and soils, which we need to cryomill, but since we do not need...
08 September 2017 6,573 2 View
Hi all, May I use the chloride ion-selective electrode with reference argentochloride electrode and Ag2S membrane suitable for an Ag(s)/AgCl(s)/KCl (aq.,sat)/Fe3+,Fe2+/(aq.)/Pt (s) system in order...
03 April 2017 9,012 7 View
01 February 2017 8,653 3 View
Are there any possibilities to determine sulfides (preferrably in the form of Na2S, Na2Sx, or H2S) from an aqueous solution, where MilliQ-water and 25 mg/L or 125 mg/L of trisodium citrate will be...
01 February 2017 6,908 1 View
31 December 2016 3,252 3 View
05 June 2016 6,240 2 View
09 October 2015 4,907 7 View
How can I easily prepare the sodium polysulfide Na2Sx, preferrably in aqueous solution? Does it the simple mixing of Na2S with sulfur powder in aqueous solution?I was searching for information in...
10 November 2014 9,252 34 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
effect of double bond on the flexibility of polymers
07 April 2021 0 0 View
I am writing to request some information for making polymer color flakes. I would appreciate the help.
17 March 2021 0 0 View
Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...
03 March 2021 8,796 3 View
I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...
03 March 2021 1,931 5 View