SiC based devices - FAQS.TIPS

Swadhin Jena @Swadhin-Jena

01 January 1970 0 394 Report

Currently, I am looking for some challenges in SiC based devices that need to be overcome.

Can anyone tell, which problem are majorly affecting SiC devices for any application?

Badges
Science topic

More Swadhin Jena's questions See All

Where can I find the spike protein amino acid sequence of SARS COV-2 variant B.1.1.7?

I need the spike protein amino acid sequence of SARS COV-2 variant B.1.1.7 (also named as VUI 202012/1)

29 December 2020 2,409 3 View

Name the journals having highest impact factors in science and pharmaceutical science?

What is the name of the journal in science having highest impact factor? and What is the name of the journal having highest impact factor in pharmaceutical sciences?

03 June 2020 7,054 6 View

How much is the EELS plasmon peak reliable for calculating Fermi energy level for alloys and compounds?

In general the low loss electron energy loss peak contain the information about the electronic structure of materials. From free electron model (Drude Model) the plasmon energy is given by a...

26 May 2020 6,315 3 View

A vaccine effective in monkey against corona virus can be 100% effective in human?

An experimental COVID-19 vaccine protected monkeys from pneumonia and prompted a strong immune response in the animals. Vincent Munster at the National Institute of Allergy and Infectious...

15 May 2020 7,939 6 View

What is the difference between drug loading and Entrapmet Efficiency of drug?

During characterization of Nano-particles, i often get confused between these two terms. Please suggest.

23 April 2020 5,178 1 View

Zeta potential of nanoparticles apart from polymers depends on which factors?

Basically i prepared PLGA based nanoparticles by QbD approach. As Zeta potential is a Critical Quality Attributes(CQA) i have to explain the effect of CMAs and CPPs on CQA. Due to PLGA polymer,...

15 April 2020 5,035 5 View

Do we always need to have error degree of freedom greater than 12 to start our research ?

I have attended different universities during my study programme and for different conference and seminars, where I notice a critical number always suggested by almost every scientist/professors...

03 December 2019 420 3 View

Climate change is real. Is it really going to have some significant negative impacts on agricultural output ?

Climate change is real and over the years the weather parameters are changing, so the global hydrological cycle, atmospheric circulation, bio-geochemical cycles also changing. But to some extent...

25 November 2019 9,336 8 View

Can I transfect the ATDC5 cells with my gene of interest at 60% confluency and then allow the cells to undergo chondrogenesis?

I am interested in studying the role of a certain gene in the expression of Collagen type II and chondrogenesis per se in ATDC5 cells. But as per the papers for proper chondrogenesis to happen it...

25 August 2019 4,652 2 View

Would you like to provide me with questionnaires for character education?

I am writing a PhD thesis on caring ethics based on the thoughts of Nel Noddings. Since it is a philosophy theses, field study is not a requirement to be fulfilled. But as i am trying to look for...

03 February 2019 8,181 3 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

Waters 2707 HPLC autosampler problem?

I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...

02 March 2021 1,408 1 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

How to calculate battery consumption for IoT device?

Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...

25 February 2021 8,749 6 View

How to troubleshoot Electrochromic Films and Electrochromic Devices?

I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...

23 February 2021 9,592 2 View

How to realize refractive index values of 1 to 1.1?

Hello researchers! While studying the literature on refractive index sensors, most of the articles simulate their devices with a refractive index ranging from 1 to 1.1, with small steps in...

17 February 2021 1,578 4 View

How to get better phase shift in C-V curves for ferroelectric devices?

I tried to sweep my ferroelectric devices from -2V to 2V and then from 2V to -2V and The two hysteresis peaks are off by several microFarads. Should i increase bias voltage? I am doing these...

16 February 2021 8,514 2 View

What are the popular techniques for pre-processing measurement data in Smart Grid/Power System?

The data collected from various measurement devices often contains erroneous values - such as noise, missing values, etc. What are the popular techniques for pre-processing measurement data in...

14 February 2021 4,642 2 View

What can I do to keep magnetic beads suspended in solution within a syringe?

I'm looking for ways to prevent the settling of magnetic beads in solution. I have been using a syringe pump to inject a suspension of magnetic beads in PBS into a microfluidic device, and so far...

09 February 2021 6,206 2 View