How it will affect the hysterisis cycle of ferroelectric device?
My purpose is to clone a human target gene (for eg:insulin gene) into a cell line and express the same in cell line for research purpose. My plan is to take RNA from human tissue and convert it to...
23 February 2017 4,101 1 View
09 March 2016 1,329 2 View
As per my research, drives me to inhibit a particular gene which codes for a protein involves in multiple functions. After treating the cells with my designed drug against that protein, i have...
14 June 2015 6,828 6 View
25 November 2014 4,218 3 View
Dear scientists, Am working in pseudomonas bacteria, where i could find lot of resistant genes, but when i extract the same with plasmid DNA extraction kit, no dna could be extracted. Is there any...
31 August 2014 8,552 8 View
Dear friends, Other than sequencing error, what could be the reason for this high no of Pseudogenes in many bacteria?
04 August 2014 201 3 View
COVID-19, causes 80% asymptomatic and only 20% critical situation among patients, who are that 20% exactly? As per my understanding, 20% people belongs to following criteria 1. Aged above 60+ 2....
01 January 1970 3,131 4 View
I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...
03 March 2021 1,931 5 View
I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...
02 March 2021 1,408 1 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...
26 February 2021 1,511 3 View
Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...
25 February 2021 8,749 6 View
I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...
23 February 2021 9,592 2 View
I ran RT-qPCR for a control and a treated group and it appears that my gene of interest was not expressed at all in any of the subjects in the control group. So I was wondering if I could...
20 February 2021 6,243 10 View
Hello researchers! While studying the literature on refractive index sensors, most of the articles simulate their devices with a refractive index ranging from 1 to 1.1, with small steps in...
17 February 2021 1,578 4 View
I tried to sweep my ferroelectric devices from -2V to 2V and then from 2V to -2V and The two hysteresis peaks are off by several microFarads. Should i increase bias voltage? I am doing these...
16 February 2021 8,514 2 View
The data collected from various measurement devices often contains erroneous values - such as noise, missing values, etc. What are the popular techniques for pre-processing measurement data in...
14 February 2021 4,642 2 View
