Regenerative energy system in EV will be a reserch hotspot in the future?
Hello
Here are the ITO material parameters and the Drude model I found in an article, but I don't know how to import these parameters correctly into Ansys lumerical FDTD.The attached picture shows the...
18 June 2024 3,182 10 View
How to create ITO materials in FDTD?
12 June 2024 5,915 2 View
Figure 1 is my plot, the background will be colored when the quantity is set to electron concentration. While Figure 2 is the figure i want. How to set the background to white color when the...
11 June 2024 8,621 1 View
I am using TfOH, DMC, dimethyldimethoxysilane and MM as the starting material, I have tried to reduce the amount of MM, but I constantly obtained low viscosity silicone oil (~100 mPa`s). I once...
21 March 2024 9,694 1 View
111
15 November 2023 829 1 View
I would like to replace the Zn atom on the surface of ZIF-8 particle by the ion exchange. I have the XRD and TEM data of ZIF-8, how many Zn atoms on the surface of this particle?
18 September 2023 5,138 3 View
Hello everyone, I am currently doing transient transfection. I want to transfect the overexpressed plasmid into HCC cells, and this plasmid has 10000+ base pairs. The transfection reagent I used...
15 July 2023 3,881 3 View
When I do the PPC-PC reverse dry transfer method, PPC and the sample fall on the PC, and then I melt the PC/ sample /PC onto the silicon chip, how do I remove both PPC and PC to get the sample?
01 July 2023 4,026 1 View
In atlas simulator, i have add interface charge with "interface" keyword, Then i start a noise simulation on this MOSFET with interface charge, but the PSD of 1/f noise shows zero with the...
01 June 2023 4,710 0 View
It is well known that the equation in the form of "ax + by = c" (where a, b and c are known integers while x and y are unknown integers) is called linear Diophantine Equation (LDE), and has been...
06 March 2023 1,514 23 View
Could you recommend some articles on Urban Transportation System optimization and Innovation?
13 August 2024 2,595 3 View
How to develop investments in renewable energy sources?
08 August 2024 5,112 3 View
Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...
31 July 2024 5,785 4 View
Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...
30 July 2024 9,824 2 View
After a lot of feature engineering for click-through rate modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing it?
29 July 2024 4,955 0 View
Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...
28 July 2024 6,553 1 View
I am looking to predict some production for future onshore wind energy production in Portugal, is there any database with info of performances of the existing wind farms in the country? something...
28 July 2024 1,750 1 View
I have different polymer solutions and I hypothesize that water molecules are retained based on the water-polymer interactions, so the amount of free water is less to intercat with drug tablet....
28 July 2024 9,545 6 View
The aim of the research here is to prevent the propagation of the crack in the fabricated elastic medium with useful applications.
25 July 2024 9,976 3 View
I am an undergraduate mechanical engineering student seeking suggestions on topics related to either thermodynamics, fluid mechanics, heat transfer or renewable energy for my final year project....
24 July 2024 4,058 5 View
