Here are the ITO material parameters and the Drude model I found in an article, but I don't know how to import these parameters correctly into Ansys lumerical FDTD.The attached picture shows the parameters
Reel kısımlar ve sanal kısımlar olmak üzere iki grup oluşturulur ve hesaplanır. Reel grup ve sanal(i) gruplar FDTD 'de oluşturulur ve aktarılır. Reel grup epsilon, epsilon sonsuz, omega, omega p ve sanal (i) grup omega ve gama olur. Buna göre denklemde elde edilen reel ve sanal değerler ile FDTD' ye aktarılır.
Şükrü Aktaş Thank you very much, but could you continue to tell me the formula for calculating the real part of the material and the formula for calculating the imaginary part?
Formül bir bütün olarak ele alınır. Elde edilen sanal ve gerçel değer ve sonuçlar FDTD 'ye aktarılır.
Şükrü Aktaş Thank you very much for your answer, is this the way to enter material parameters directly in FDTD?
Dear Şükrü Aktaş,
As I can see you have an expertise in photonics and help a lot of people that I appreciate. But, I noticed that you answer question not in English, even if a question was asked in English. It requires for each reader to translate your answer and sometimes the translation is not 100% correct.
So, if you don’t mind, may I ask you to answer the question in English, if the question was initially formulated in English. It will make the readers life much easier.
Best wishes
Sergei Rodionov
I see.
Then there is nothing to do with this, except to learn English. But it’s only up to you.
Anyway, thank you for what you do and for the feedback.
Şükrü Aktaş Thank you, very much for your answers during this time. I was unable to answer your message in time due to personal reasons, and even then you were able to answer my questions in a timely manner.
- Badges
- Science topic
- Similar topics
- Heat